Author Topic: Teardown of a Ericsson radio base station, the RBS6000 system  (Read 1421 times)

Offline Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1457
  • Karma: +24/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
All technical details and high resolution pictures: http://kaizerpowerelectronics.dk/teardown/ericsson-radio-base-station-rbs6000-teardown/

The RBS6000 is an indoor Radio Base Station with one to four carriers and one to  six sectors at 20/40 Watt RF output power per carrier.

http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics
https://www.youtube.com/KaizerPowerElectronicsDk60/join - Please consider supporting the forum, websites and youtube channel!

Offline Da_Stier

  • High Voltage Enthusiast
  • *
  • Posts: 32
  • Karma: +1/-0
    • View Profile
Re: Teardown of a Ericsson radio base station, the RBS6000 system
« Reply #1 on: October 10, 2019, 05:33:50 PM »
Since I needed some S21 measurement for generating a .S2P file for some testing, I dug out a RBS6000 radio unit I have.
I measured the S21 characteristic of the TX output filter.



As expected, the center frequency lies right at 750MHz.
The -3dB bandwith of the filter is around 16MHz, which gives the filter a Q factor of over 46, wich I found quite amazing.



Hope this is interesting to some of you, even though this topic is quite old.

Offline Da_Stier

  • High Voltage Enthusiast
  • *
  • Posts: 32
  • Karma: +1/-0
    • View Profile
Re: Teardown of a Ericsson radio base station, the RBS6000 system
« Reply #2 on: November 01, 2019, 11:47:33 AM »
Since I measured the TX Filter of the RBS6000 side, I got curious how the RX side of the filter would look like.
So I got myself some SMP to SMA pigtails and measured the RX side as well.

The results were quite interesting, not because of the filter caractaristics (they were quite obvious) but because how perfectly matched the two channels were.





Note how the two plots of the two RX channels are basically identical except the noise floor.
I didn't even have to move the cursors at all, they just matched.
I find that quite amazing and am wondering how much time is invested in tuning each one of these filters up to spec.


Greetings
Da_Stier

High Voltage Forum

Re: Teardown of a Ericsson radio base station, the RBS6000 system
« Reply #2 on: November 01, 2019, 11:47:33 AM »

 


* Recent Topics and Posts

post Single sided use of Xray XFMR
[Transformer (Ferrite Core)]
HighVoltageRulezz
August 10, 2020, 12:23:05 PM
post Re: XRay Tank- any ideas about what is inside
[Transformer (Ferrite Core)]
HighVoltageRulezz
August 10, 2020, 12:18:04 PM
post Re: making HV bobbins for ferrite transformers
[Transformer (Ferrite Core)]
johnf
August 10, 2020, 10:24:54 AM
post Re: making HV bobbins for ferrite transformers
[Transformer (Ferrite Core)]
davekni
August 10, 2020, 06:20:04 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General Chat]
RoadReaper
August 10, 2020, 05:40:19 AM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
August 10, 2020, 02:07:26 AM
post making HV bobbins for ferrite transformers
[Transformer (Ferrite Core)]
Teravolt
August 10, 2020, 01:27:22 AM
post A Tesla coil and an antenna
[General Chat]
TheFreq
August 09, 2020, 09:02:32 PM
post Re: Fun with wireless power
[Solid State Tesla Coils (SSTC)]
Steve Ward
August 08, 2020, 10:22:04 PM
post Re: Fun with wireless power
[Solid State Tesla Coils (SSTC)]
T3sl4co1l
August 08, 2020, 03:36:40 PM
post Re: Fun with wireless power
[Solid State Tesla Coils (SSTC)]
acmq
August 08, 2020, 02:07:52 AM
post Re: LSI Nitrogen Laser tear-down and Homemade TEA Nitrogen and Dye Lasers
[Light, Lasers and Optics]
LesWright
August 06, 2020, 10:20:12 PM
post Re: LSI Nitrogen Laser tear-down and Homemade TEA Nitrogen and Dye Lasers
[Light, Lasers and Optics]
Weston
August 06, 2020, 08:45:59 PM
post Re: Cathodes in Compact Fluorescent Lamps
[Light, Lasers and Optics]
klugesmith
August 06, 2020, 05:41:04 PM
post Re: Dual MOT tesla coil
[Spark Gap Tesla Coils (SGTC)]
Jun
August 06, 2020, 03:53:58 PM
post LSI Nitrogen Laser tear-down and Homemade TEA Nitrogen and Dye Lasers
[Light, Lasers and Optics]
LesWright
August 06, 2020, 03:28:14 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
AstRii
August 06, 2020, 12:59:03 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
August 06, 2020, 10:51:43 AM
post Re: How much is the voltage used in Corona Discharge tubes for ozone Generation?
[Transformer (Ferrite Core)]
UB_Serpent
August 06, 2020, 08:40:57 AM
post Re: compact midi interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
TMaxElectronics
August 06, 2020, 03:22:38 AM
post Re: Dual MOT tesla coil
[Spark Gap Tesla Coils (SGTC)]
davekni
August 05, 2020, 11:48:55 PM
post Re: How much is the voltage used in Corona Discharge tubes for ozone Generation?
[Transformer (Ferrite Core)]
davekni
August 05, 2020, 11:37:13 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
AstRii
August 05, 2020, 08:01:11 PM
post Re: Fun with wireless power
[Solid State Tesla Coils (SSTC)]
Lightning On Demand
August 05, 2020, 06:34:08 PM
post Re: How much is the voltage used in Corona Discharge tubes for ozone Generation?
[Transformer (Ferrite Core)]
Uspring
August 05, 2020, 12:56:32 PM
post Re: Fun with wireless power
[Solid State Tesla Coils (SSTC)]
Mads Barnkob
August 05, 2020, 12:55:52 PM
post Re: Bipolar high voltage multiplier project - more than 70cm hot arc discharge
[Voltage Multipliers]
Teravolt
August 04, 2020, 09:21:09 PM
post Re: How much is the voltage used in Corona Discharge tubes for ozone Generation?
[Transformer (Ferrite Core)]
johnf
August 04, 2020, 09:16:55 PM
post Re: Does anyone know how this site works.
[General Chat]
thedoc298
August 04, 2020, 05:53:03 PM
post Re: Does anyone know how this site works.
[General Chat]
thedoc298
August 04, 2020, 05:51:03 PM
post Re: Fun with wireless power
[Solid State Tesla Coils (SSTC)]
Lightning On Demand
August 04, 2020, 05:17:26 PM
post Re: Fun with wireless power
[Solid State Tesla Coils (SSTC)]
Max
August 04, 2020, 02:14:56 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
August 04, 2020, 02:08:07 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
futurist
August 04, 2020, 10:48:35 AM
post Re: How much is the voltage used in Corona Discharge tubes for ozone Generation?
[Transformer (Ferrite Core)]
UB_Serpent
August 04, 2020, 10:02:39 AM
post Re: Dual MOT tesla coil
[Spark Gap Tesla Coils (SGTC)]
Jun
August 04, 2020, 08:47:07 AM
post Re: Dual MOT tesla coil
[Spark Gap Tesla Coils (SGTC)]
Jun
August 04, 2020, 08:43:00 AM
post Re: Does anyone know how this site works.
[General Chat]
Mads Barnkob
August 04, 2020, 08:33:47 AM
post Re: Does anyone know how this site works.
[General Chat]
MRMILSTAR
August 04, 2020, 05:09:26 AM
post Does anyone know how this site works.
[General Chat]
thedoc298
August 04, 2020, 01:54:49 AM
post Fun with wireless power
[Solid State Tesla Coils (SSTC)]
Lightning On Demand
August 03, 2020, 11:55:41 PM
post Re: Dual MOT tesla coil
[Spark Gap Tesla Coils (SGTC)]
Teravolt
August 03, 2020, 09:17:40 PM
post Re: Dual MOT tesla coil
[Spark Gap Tesla Coils (SGTC)]
MRMILSTAR
August 03, 2020, 08:30:38 PM
post Re: Budget USB cameras
[High Speed Filming]
missoum0514
August 03, 2020, 06:56:08 PM
post Re: Dual MOT tesla coil
[Spark Gap Tesla Coils (SGTC)]
Jun
August 03, 2020, 05:23:15 PM
post Re: Is my xray transformer a ferrite core and how would I drive it?
[Transformer (Ferrite Core)]
nielsquake
August 03, 2020, 05:02:26 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
August 03, 2020, 04:31:04 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
futurist
August 03, 2020, 10:05:59 AM
post Re: Is my xray transformer a ferrite core and how would I drive it?
[Transformer (Ferrite Core)]
Mads Barnkob
August 03, 2020, 08:21:26 AM
post Re: Is my xray transformer a ferrite core and how would I drive it?
[Transformer (Ferrite Core)]
nielsquake
August 02, 2020, 11:45:38 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal