Author Topic: Corona on the.... GDT??  (Read 556 times)

Offline nick

  • High Voltage Enthusiast
  • *
  • Posts: 13
  • Karma: +0/-0
    • View Profile
Corona on the.... GDT??
« on: November 29, 2019, 12:40:05 PM »
Weird experience I had yesterday. I built a GDT for a full bridge but was testing it on my half bridge. The coil worked as expected (albeit I mostly test at voltages ~45v) but I spent probably 15 minutes trying to figure out where the sound of a second spark breakout was taking place (in addition to the breakout point). I was then surprised to notice that the sound was coming from the GDT (with 2 coils left open) and even more surprised to see a light corona between the wires... it was weird but kind of pretty.

Anyway when I connect it to the full bridge, this effect disappears (unfortunately the coil itself doesn't work but that's another story....).

I'm guessing the disconnected windings are acting like antennas? Interesting that it doesn't seem to negatively affect the performance of the half bridge....

Offline Weston

  • High Voltage Experimenter
  • **
  • Posts: 73
  • Karma: +5/-0
    • View Profile
Re: Corona on the.... GDT??
« Reply #1 on: December 01, 2019, 12:14:57 PM »
Is your driver circuit grounded? Are you using antenna feedback? The secondary wires are close to the primary windings so the electric field for the two should be ~ the same, so unless things are really wired weird I don't think the unconnected windings are acting like an antenna. If you wanted to eliminate this as a cause you could connect one side of the unconnected GDT winding to a connected winding.

The secondary side of the GDT is referenced to the inverter, which has low impedance paths to defined voltages. Any voltage is likely between the primary and secondary, which means your driver circuit could be floating referenced to the inverter. Are you using a separate power supply for the driver? Is there a common ground or something?

High Voltage Forum

Re: Corona on the.... GDT??
« Reply #1 on: December 01, 2019, 12:14:57 PM »

 


* Recent Topics and Posts

post Re: IGBTs keep dying (un-solved again)
[Dual Resonant Solid State Tesla coils (DRSSTC)]
TMaxElectronics
July 04, 2020, 10:35:50 PM
post Re: IGBTs keep dying (un-solved again)
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 04, 2020, 08:56:15 PM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
TMaxElectronics
July 04, 2020, 04:37:32 PM
post Re: IGBTs keep dying (un-solved again)
[Dual Resonant Solid State Tesla coils (DRSSTC)]
TMaxElectronics
July 04, 2020, 04:14:44 PM
post Dell PowerEdge M1000E Blade Server Teardown
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
July 04, 2020, 01:52:14 PM
post Help needed: HV Driver circuit
[Transformer (Ferrite Core)]
HighVoltageRulezz
July 04, 2020, 12:37:48 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
July 04, 2020, 12:17:47 AM
post Cathodes in Compact Fluorescent Lamps
[Light, Lasers and Optics]
klugesmith
July 03, 2020, 07:12:18 AM
post Re: What's needed to heat up 0.75 g of SiC (susceptor) mass until it turns dim-red??
[Radio Frequency]
klugesmith
July 03, 2020, 06:36:16 AM
post Re: IGBTs keep dying (un-solved again)
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 03, 2020, 04:20:42 AM
post Re: "Slayer exciter" analysis
[Solid State Tesla Coils (SSTC)]
acmq
July 03, 2020, 03:01:56 AM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
AstRii
July 02, 2020, 11:17:48 PM
post Re: How to prevent secondary oxidation / Rust
[Dual Resonant Solid State Tesla coils (DRSSTC)]
MRMILSTAR
July 02, 2020, 11:09:25 PM
post Re: Differential probe testing setup
[Laboratories, Equipment and Tools]
TMaxElectronics
July 02, 2020, 10:57:02 PM
post Re: Differential probe testing setup
[Laboratories, Equipment and Tools]
Twospoons
July 02, 2020, 10:47:18 PM
post Re: How to prevent secondary oxidation / Rust
[Dual Resonant Solid State Tesla coils (DRSSTC)]
johnf
July 02, 2020, 09:03:20 PM
post Re: How to prevent secondary oxidation / Rust
[Dual Resonant Solid State Tesla coils (DRSSTC)]
DJthefirst
July 02, 2020, 08:01:03 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
July 02, 2020, 07:04:55 PM
post Re: How to prevent secondary oxidation / Rust
[Dual Resonant Solid State Tesla coils (DRSSTC)]
TMaxElectronics
July 02, 2020, 07:02:30 PM
post Re: IGBTs keep dying (solved for now)
[Dual Resonant Solid State Tesla coils (DRSSTC)]
TMaxElectronics
July 02, 2020, 06:51:20 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
AstRii
July 02, 2020, 05:34:23 PM
post Re: How to prevent secondary oxidation / Rust
[Dual Resonant Solid State Tesla coils (DRSSTC)]
DJthefirst
July 02, 2020, 05:09:09 PM
post Re: How to prevent secondary oxidation / Rust
[Dual Resonant Solid State Tesla coils (DRSSTC)]
TMaxElectronics
July 02, 2020, 12:51:29 PM
post Differential probe testing setup
[Laboratories, Equipment and Tools]
TMaxElectronics
July 02, 2020, 12:20:18 PM
post Re: How to prevent secondary oxidation / Rust
[Dual Resonant Solid State Tesla coils (DRSSTC)]
MRMILSTAR
July 02, 2020, 05:30:41 AM
post How to prevent secondary oxidation / Rust
[Dual Resonant Solid State Tesla coils (DRSSTC)]
DJthefirst
July 02, 2020, 04:16:58 AM
post Re: induction heater troubleshooting help
[Electronic Circuits]
petespaco
July 02, 2020, 01:02:02 AM
post Re: What's needed to heat up 0.75 g of SiC (susceptor) mass until it turns dim-red??
[Radio Frequency]
T3sl4co1l
July 01, 2020, 06:54:30 AM
post Re: "Slayer exciter" analysis
[Solid State Tesla Coils (SSTC)]
T3sl4co1l
July 01, 2020, 06:25:30 AM
post Re: "Slayer exciter" analysis
[Solid State Tesla Coils (SSTC)]
acmq
July 01, 2020, 02:47:13 AM
post Re: A three-phase "tree phase" Tesla coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Steve Ward
July 01, 2020, 02:43:34 AM
post Re: induction heater troubleshooting help
[Electronic Circuits]
aes92000
July 01, 2020, 02:33:07 AM
post Re: induction heater troubleshooting help
[Electronic Circuits]
petespaco
July 01, 2020, 12:03:08 AM
post Re: induction heater troubleshooting help
[Electronic Circuits]
aes92000
June 30, 2020, 10:34:36 PM
post Re: E-Bay Marx generator
[Voltage Multipliers]
ritaismyconscience
June 30, 2020, 09:14:06 PM
post Re: What's needed to heat up 0.75 g of SiC (susceptor) mass until it turns dim-red??
[Radio Frequency]
ritaismyconscience
June 30, 2020, 09:05:32 PM
post Re: induction heater troubleshooting help
[Electronic Circuits]
ritaismyconscience
June 30, 2020, 09:01:55 PM
post Re: A three-phase "tree phase" Tesla coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Weston
June 30, 2020, 08:22:33 PM
post Re: "Slayer exciter" analysis
[Solid State Tesla Coils (SSTC)]
Weston
June 30, 2020, 07:54:40 PM
post "Slayer exciter" analysis
[Solid State Tesla Coils (SSTC)]
acmq
June 30, 2020, 05:13:57 PM
post induction heater troubleshooting help
[Electronic Circuits]
aes92000
June 30, 2020, 04:08:34 PM
post Re: 100$ Thermal Camera With 32x32 Pixel. HTi HT-02D Unboxing And Test
[Laboratories, Equipment and Tools]
Mads Barnkob
June 30, 2020, 02:54:22 PM
post Re: A three-phase "tree phase" Tesla coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
June 30, 2020, 01:04:30 PM
post Re: What's needed to heat up 0.75 g of SiC (susceptor) mass until it turns dim-red??
[Radio Frequency]
Justin
June 30, 2020, 10:07:49 AM
post Re: What's needed to heat up 0.75 g of SiC (susceptor) mass until it turns dim-red??
[Radio Frequency]
Twospoons
June 29, 2020, 12:43:36 AM
post Re: A three-phase "tree phase" Tesla coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Hydron
June 28, 2020, 12:57:53 PM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Hydron
June 28, 2020, 12:24:17 PM
post Re: 100$ Thermal Camera With 32x32 Pixel. HTi HT-02D Unboxing And Test
[Laboratories, Equipment and Tools]
davekni
June 28, 2020, 02:19:44 AM
post E-Bay Marx generator
[Voltage Multipliers]
MRMILSTAR
June 27, 2020, 09:36:57 PM
post A three-phase "tree phase" Tesla coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Steve Ward
June 27, 2020, 09:28:56 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal