Author Topic: SSTC stopped working HELP  (Read 364 times)

Offline Saattvik24

  • High Voltage Enthusiast
  • *
  • Posts: 5
  • Karma: +0/-0
    • View Profile
SSTC stopped working HELP
« on: October 06, 2019, 08:12:14 PM »
I was driving my half bridge sstc based kaizerelectronics sstc 1 on 100 volt AC input on continuous mode, and after a few runs it stopped working and I know it didn't die due to overheating cause I only ran it for short intervals of time and I even had a fan attached to the heatsinks. Now when I power it, it doesn't make any sparks but it faintly lights a cfl when I bring it very close to the top load, so I guess its not completely destroyed. At first I thought I blew up the bridge rectifier because it was only rated for 4 amps so I got a new one rated for 35 amps but it still does the same thing and doesn't work properly. I think the driver works fine and the problem is with the bridge circuit, maybe the mosfets or the half bridge capacitors or the diodes. So I'll be glad if you can help me diagnose it and fix it :)

Offline oneKone

  • High Voltage Engineer
  • ****
  • Posts: 289
  • Karma: +8/-0
    • View Profile
Re: SSTC stopped working HELP
« Reply #1 on: October 07, 2019, 12:54:02 AM »
It would help if you could post some pictures.

By the sounds of it you've killed a MOSFET.
You can see if a MOSFET/igbt is dead with a dmm in diode/continuity mode.

Offline Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1262
  • Karma: +18/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
Re: SSTC stopped working HELP
« Reply #2 on: October 07, 2019, 08:50:42 AM »
I agree with oneKone

It sounds like you have one half-/dead MOSFET in your half-bridge. So a small amount of energy is still being pumped/leaked into the primary circuit and it only takes a few Watt of power to make a secondary circuit light up a CFL.

It could even just be your driver circuit coupling energy through the GDT and power the primary circuit from there, I demonstrate that exact behavior in this video where there is no power on the bridge.

http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics

Offline Saattvik24

  • High Voltage Enthusiast
  • *
  • Posts: 5
  • Karma: +0/-0
    • View Profile
Re: SSTC stopped working HELP
« Reply #3 on: October 07, 2019, 08:14:14 PM »
I checked both the mosfets and they are both working, so what else could be wrong? When I ran the tesla coil I measured the voltage across both the half bridge capacitors, across one of them was the input voltage and across the other it was only 3 volts, so maybe one of the capacitor is dead???

Offline davekni

  • High Voltage Technician
  • ***
  • Posts: 193
  • Karma: +5/-0
  • Physicist, engineer (electronic), and hobbiest
    • View Profile
Re: SSTC stopped working HELP
« Reply #4 on: October 08, 2019, 05:05:17 AM »
Any chance you can make some oscilloscope measurements?  A circuit diagram and a few scope captures would help in figuring out what failed.
David Knierim

High Voltage Forum

Re: SSTC stopped working HELP
« Reply #4 on: October 08, 2019, 05:05:17 AM »

 


* Recent Topics and Posts

post Finding accelerometer location inside a phone
[Smart Phones]
haversin
Today at 07:23:28 PM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
dj.cosmo.esq
Today at 07:41:18 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
Today at 06:49:22 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
Today at 03:39:10 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
Quentief
Today at 02:32:55 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
klugesmith
Today at 02:10:34 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
Quentief
Today at 01:27:41 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Hydron
February 21, 2020, 08:00:10 PM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
February 21, 2020, 02:44:44 PM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
klugesmith
February 21, 2020, 07:21:13 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
February 21, 2020, 06:11:32 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
February 21, 2020, 04:42:34 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
davekni
February 21, 2020, 04:37:53 AM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
Twospoons
February 21, 2020, 04:28:33 AM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
klugesmith
February 21, 2020, 04:21:31 AM
post GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
February 21, 2020, 02:41:03 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
Quentief
February 21, 2020, 12:28:20 AM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
Twospoons
February 20, 2020, 09:45:21 PM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
klugesmith
February 20, 2020, 07:28:01 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Uspring
February 20, 2020, 02:06:26 PM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
shrad
February 20, 2020, 10:38:01 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
davekni
February 20, 2020, 05:14:43 AM
post Re: Is this flyback OK for my Plasma ball ?
[Transformer (Ferrite Core)]
davekni
February 20, 2020, 05:04:50 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
klugesmith
February 20, 2020, 04:47:41 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 19, 2020, 07:29:23 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 19, 2020, 06:47:55 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 19, 2020, 06:45:23 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Teravolt
February 19, 2020, 06:41:42 PM
post Re: Is this flyback OK for my Plasma ball ?
[Transformer (Ferrite Core)]
John123
February 19, 2020, 06:10:34 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
MRMILSTAR
February 19, 2020, 05:52:20 PM
post Re: Is this flyback OK for my Plasma ball ?
[Transformer (Ferrite Core)]
ElectroXa
February 19, 2020, 05:05:50 PM
post Re: Is this flyback OK for my Plasma ball ?
[Transformer (Ferrite Core)]
John123
February 19, 2020, 04:11:22 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Uspring
February 19, 2020, 02:03:12 PM
post Is this flyback OK for my Plasma ball ?
[Transformer (Ferrite Core)]
warmania
February 19, 2020, 11:24:58 AM
post Re: HP T620 Thin Client - PSU Hack And Windows PC Modification
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
latethannever
February 19, 2020, 11:00:15 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
rikkitikkitavi
February 19, 2020, 10:43:13 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 19, 2020, 06:54:14 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
klugesmith
February 19, 2020, 06:51:52 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
davekni
February 19, 2020, 03:53:13 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
ElectroXa
February 18, 2020, 09:44:25 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
MRMILSTAR
February 18, 2020, 09:34:06 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 18, 2020, 08:27:31 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Weston
February 18, 2020, 07:55:14 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 18, 2020, 07:32:04 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
klugesmith
February 18, 2020, 05:58:39 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
MRMILSTAR
February 18, 2020, 05:16:55 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 18, 2020, 04:19:37 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Mads Barnkob
February 18, 2020, 04:12:11 PM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
Quentief
February 18, 2020, 01:25:06 PM
post Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 18, 2020, 10:40:58 AM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal