Author Topic: 30% power increase  (Read 452 times)

Offline MRMILSTAR

  • High Voltage Technician
  • ***
  • Posts: 155
  • Karma: +4/-0
  • Cedar Rapids, Iowa
    • View Profile
30% power increase
« on: August 06, 2019, 04:35:37 PM »
I recently increased the power of my big SGTC by about 30%, from 4.8 KVA to 6.5 KVA. This was very simple to do on my equipment. All I had to do was increase the air gap on my ballast very slightly. JAVATC predicted a 9-foot maximum streamer length. A neighbor took the attached picture. If I stretch out all of the kinks, the streamer length does indeed measure to about 9 feet. For reference the coil is 75" tall.

This is the maximum power that I can safely use with my current components. My weak link is my variac which is the largest General Radio variac available. It is rated for 240 volts at 25 amps continuous and up to 32 amps with cooling intervals. My current power level draws 27 amps, with PFC, through the variac. This is the maximum that I am comfortable with unless I want to make major modifications (2 ganged variacs and more capacitance).
Steve White
Cedar Rapids, Iowa
Retired electrical engineer

Online Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1267
  • Karma: +18/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
Re: 30% power increase
« Reply #1 on: August 08, 2019, 08:33:01 AM »
I was never so bold to "stretch" out the spark for spark length measurements  :P

Most variacs are rated for 200-300% operation for very short periods, it will however hum violently, just if you wanted to push things a bit :)
http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics

Offline MRMILSTAR

  • High Voltage Technician
  • ***
  • Posts: 155
  • Karma: +4/-0
  • Cedar Rapids, Iowa
    • View Profile
Re: 30% power increase
« Reply #2 on: August 08, 2019, 04:18:09 PM »
The GR variacs also have an internal fuse which I believe is rated for 32 amps, so that is another limitation. I could just bypass the fuse since my control cabinet has a 40 amp breaker. However, going higher than 27 amps would be largely pointless without increasing the size of my primary circuit capacitance. With my 45 nF capacitance, JAVATC says that my capacitors are 95% charged at the start of each bang (240 BPS) with 27 amps. I could increase the capacitance to 60 nF since I do have additional Maxwell energy discharge capacitors. I might do that some day but for now, 9-foot streamers satisfy me.

My ultimate limit though are the 40 amp breakers in my distribution panel.
« Last Edit: August 08, 2019, 04:22:59 PM by MRMILSTAR »
Steve White
Cedar Rapids, Iowa
Retired electrical engineer

High Voltage Forum

Re: 30% power increase
« Reply #2 on: August 08, 2019, 04:18:09 PM »

 


* Recent Topics and Posts

post Re: Unusually long-lived electrolytic capacitor
[Electronic Circuits]
ritaismyconscience
Today at 06:08:05 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
Today at 05:55:55 AM
post Re: Unusually long-lived electrolytic capacitor
[Electronic Circuits]
T3sl4co1l
Today at 05:51:48 AM
post Unusually long-lived electrolytic capacitor
[Electronic Circuits]
MRMILSTAR
Today at 05:43:34 AM
post Re: Tesla coil Toroid Aluminium tape benefit
[Spark Gap Tesla Coils (SGTC)]
Jun
February 25, 2020, 01:26:37 PM
post Re: Tesla coil Toroid Aluminium tape benefit
[Spark Gap Tesla Coils (SGTC)]
dj.cosmo.esq
February 25, 2020, 01:05:01 PM
post Re: Tesla coil Toroid Aluminium tape benefit
[Spark Gap Tesla Coils (SGTC)]
Jun
February 25, 2020, 12:35:06 PM
post Re: FPS4000
[High Speed Filming]
Mads Barnkob
February 25, 2020, 11:29:58 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
February 25, 2020, 08:28:28 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
February 25, 2020, 06:27:40 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
February 25, 2020, 06:20:04 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
February 25, 2020, 04:23:50 AM
post Re: Tesla coil Toroid Aluminium tape benefit
[Spark Gap Tesla Coils (SGTC)]
Mads Barnkob
February 24, 2020, 02:53:13 PM
post Tesla coil Toroid Aluminium tape benefit
[Spark Gap Tesla Coils (SGTC)]
Jun
February 24, 2020, 02:38:29 PM
post Re: NST
[Spark Gap Tesla Coils (SGTC)]
Jun
February 24, 2020, 02:30:28 PM
post FPS4000
[High Speed Filming]
Hoser415
February 24, 2020, 02:21:50 PM
post Re: HP T620 thin to plus conversion....
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
February 24, 2020, 09:09:33 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
February 24, 2020, 07:08:30 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
February 24, 2020, 04:37:33 AM
post Re: DIY 250W LED Flood Light for High Speed Filming
[Light, Lasers and Optics]
Mads Barnkob
February 23, 2020, 09:04:34 PM
post HP T620 thin to plus conversion....
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
spacecabbie
February 23, 2020, 02:03:15 PM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
February 23, 2020, 05:43:17 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
klugesmith
February 23, 2020, 04:07:51 AM
post Finding accelerometer location inside a phone
[Smart Phones]
haversin
February 22, 2020, 07:23:28 PM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
dj.cosmo.esq
February 22, 2020, 07:41:18 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
February 22, 2020, 06:49:22 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
February 22, 2020, 03:39:10 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
Quentief
February 22, 2020, 02:32:55 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
klugesmith
February 22, 2020, 02:10:34 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
Quentief
February 22, 2020, 01:27:41 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Hydron
February 21, 2020, 08:00:10 PM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
February 21, 2020, 02:44:44 PM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
klugesmith
February 21, 2020, 07:21:13 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
February 21, 2020, 06:11:32 AM
post Re: GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
February 21, 2020, 04:42:34 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
davekni
February 21, 2020, 04:37:53 AM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
Twospoons
February 21, 2020, 04:28:33 AM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
klugesmith
February 21, 2020, 04:21:31 AM
post GDT keeps on killing IGBTs
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
February 21, 2020, 02:41:03 AM
post Re: 230 volts spark gap
[Spark Gap Tesla Coils (SGTC)]
Quentief
February 21, 2020, 12:28:20 AM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
Twospoons
February 20, 2020, 09:45:21 PM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
klugesmith
February 20, 2020, 07:28:01 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Uspring
February 20, 2020, 02:06:26 PM
post Re: UV-cured cyanoacrylate glues?
[Light, Lasers and Optics]
shrad
February 20, 2020, 10:38:01 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
davekni
February 20, 2020, 05:14:43 AM
post Re: Is this flyback OK for my Plasma ball ?
[Transformer (Ferrite Core)]
davekni
February 20, 2020, 05:04:50 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
klugesmith
February 20, 2020, 04:47:41 AM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 19, 2020, 07:29:23 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 19, 2020, 06:47:55 PM
post Re: Help!Capacitor that burns out after a while!
[Voltage Multipliers]
Peregrine
February 19, 2020, 06:45:23 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal