Author Topic: Choke-input DC-filter  (Read 153 times)

Offline kamelryttarn

  • High Voltage Technician
  • ***
  • Posts: 100
  • Karma: +0/-0
    • View Profile
Choke-input DC-filter
« on: June 20, 2019, 11:43:58 AM »
The other day I received an arduino shield for my motorcycle tachometer project. It will be used to convert the ~12V system to 5V and also provide a little backup power.

Since there is a fair amount of noise on the electrical system I figured it would be a good idea to add some kind of filter on top of the filtration the shield will provide for me so I bought a DC choke of 320mH rated for 600mA with a specified DC resistance of 7.8 Ohm. My goal is to remove some of the worst spikes and dips but do I NEED a capacitor as well and should I place it before or after the choke? I know a capacitor will make the filter circuit perform BETTER but what I would like to know is if I MUST place a capacitor just before or after or if it's just good practice. Can a choke WITHOUT a capacitor even make things worse and possibly break certain components?

My initial plan is to use my oscilloscope and measure before and after the choke to see what kind of difference it makes but if just a single choke can actually make things worse and damage my shield I do not want to do that before I have checked with people who has a better understanding about this than I do. All information I can find about chokes refers to using the after a rectifier bridge @ 50/60Hz

Offline johnf

  • High Voltage Enthusiast
  • *
  • Posts: 11
  • Karma: +0/-0
    • View Profile
Re: Choke-input DC-filter
« Reply #1 on: June 20, 2019, 12:09:27 PM »
I prefer after the choke so as to minimise circulating current around the filter this also tends to let you use lower value caps that have higher self resonant frequencies so the filter works to higher frequencies

Offline kamelryttarn

  • High Voltage Technician
  • ***
  • Posts: 100
  • Karma: +0/-0
    • View Profile
Re: Choke-input DC-filter
« Reply #2 on: June 20, 2019, 12:53:58 PM »
But isn't there a risk that the cap placed after the choke will try to feed current back when cranking the starter motor? Short circuit current will be close to 2A . Won't that hurt the choke?

Offline johnf

  • High Voltage Enthusiast
  • *
  • Posts: 11
  • Karma: +0/-0
    • View Profile
Re: Choke-input DC-filter
« Reply #3 on: June 20, 2019, 08:58:07 PM »
the cap will try to hold up your feed to your regulator the choke will limit current flowing back
No it will n ot damage choke for a small shortime slight overload.
The worst thta can happen is the choke saturates effectively removing its core making the coke equal to it being air cored while it is in saturation
It immediately recovers after the overload to be as it should

High Voltage Forum

Re: Choke-input DC-filter
« Reply #3 on: June 20, 2019, 08:58:07 PM »

 


* Recent Topics and Posts

post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
Bert911
Today at 11:19:45 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
Today at 03:36:44 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
DICKEYBIRD
Today at 03:24:38 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
Today at 02:23:29 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
DICKEYBIRD
Today at 01:06:44 AM
post Re: Floppiclene! A Electronics Cleaning Relic of the Past.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Justin
July 18, 2019, 10:29:32 PM
post Re: Floppiclene! A Electronics Cleaning Relic of the Past.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
July 18, 2019, 08:52:35 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
July 18, 2019, 05:49:27 AM
post A new quick way to get into tune a DRSSTC
[Dual Resonant Solid State Tesla coils]
VNTC
July 18, 2019, 03:13:27 AM
post Re: Floppiclene! A Electronics Cleaning Relic of the Past.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Twospoons
July 18, 2019, 12:06:53 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
July 17, 2019, 07:56:41 PM
post Floppiclene! A Electronics Cleaning Relic of the Past.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
July 17, 2019, 11:25:22 AM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
Netzpfuscher
July 16, 2019, 07:39:33 AM
post Re: What is the true in tuning guide?
[Dual Resonant Solid State Tesla coils]
VNTC
July 16, 2019, 05:11:21 AM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
profdc9
July 16, 2019, 04:05:07 AM
post Re: DRSSTC in brust mode
[Dual Resonant Solid State Tesla coils]
SAMGO
July 16, 2019, 02:25:27 AM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
Hydron
July 16, 2019, 01:54:30 AM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 15, 2019, 02:51:26 PM
post Re: What is the true in tuning guide?
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 15, 2019, 02:48:02 PM
post Re: A problem solved with hand tools
[General chatting]
Mads Barnkob
July 15, 2019, 01:48:08 PM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 15, 2019, 01:45:00 PM
post Re: A problem solved with hand tools
[General chatting]
Hydron
July 15, 2019, 11:21:29 AM
post What is the true in tuning guide?
[Dual Resonant Solid State Tesla coils]
VNTC
July 15, 2019, 10:01:21 AM
post A problem solved with hand tools
[General chatting]
klugesmith
July 15, 2019, 07:52:41 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
klugesmith
July 15, 2019, 07:33:30 AM
post Re: tesla coil varnish is dumb
[Solid state Tesla coils]
Hydron
July 14, 2019, 10:49:03 PM
post Re: tesla coil varnish is dumb
[Solid state Tesla coils]
T3sl4co1l
July 14, 2019, 09:59:40 PM
post Re: tesla coil varnish is dumb
[Solid state Tesla coils]
Mads Barnkob
July 14, 2019, 08:20:52 PM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
Netzpfuscher
July 14, 2019, 06:06:30 PM
post tesla coil varnish is dumb
[Solid state Tesla coils]
Fumeaux
July 14, 2019, 05:29:10 PM
post Led Closeups with Mobile phone and lens .
[Smart phones]
DashApple
July 14, 2019, 03:00:09 PM
post Re: Drsstc 3
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 14, 2019, 02:06:26 PM
post Re: DRSSTC in brust mode
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 14, 2019, 02:04:22 PM
post Re: Twin System Build
[Dual Resonant Solid State Tesla coils]
oneKone
July 14, 2019, 01:27:18 AM
post Re: DRSSTC in brust mode
[Dual Resonant Solid State Tesla coils]
johnf
July 14, 2019, 01:22:15 AM
post Re: Drsstc 3
[Dual Resonant Solid State Tesla coils]
oneKone
July 13, 2019, 03:48:54 PM
post DRSSTC in brust mode
[Dual Resonant Solid State Tesla coils]
SAMGO
July 13, 2019, 04:17:55 AM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
donnersm
July 12, 2019, 08:54:54 PM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
profdc9
July 12, 2019, 07:16:40 PM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
profdc9
July 12, 2019, 06:33:00 PM
post Smooth corona or heavy spark, RF wave radiation frequency of Tesla coil drops ve
[Dual Resonant Solid State Tesla coils]
VNTC
July 12, 2019, 11:09:28 AM
post Re: Drsstc 3
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 12, 2019, 09:56:38 AM
post Re: Drsstc 3
[Dual Resonant Solid State Tesla coils]
oneKone
July 12, 2019, 01:23:58 AM
post Re: Completed my pulsed power generator
[Capacitor banks]
MRMILSTAR
July 11, 2019, 05:48:27 PM
post Re: Completed my pulsed power generator
[Capacitor banks]
Mads Barnkob
July 11, 2019, 02:58:13 PM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 11, 2019, 02:45:24 PM
post Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
donnersm
July 11, 2019, 06:59:01 AM
post Completed my pulsed power generator
[Capacitor banks]
MRMILSTAR
July 11, 2019, 05:43:31 AM
post Re: Twin System Build
[Dual Resonant Solid State Tesla coils]
fnordest
July 11, 2019, 01:05:42 AM
post Re: "LightningStorm" VTTC project
[Vacuum tube Tesla coils]
Avenger
July 09, 2019, 07:31:37 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30