Author Topic: Huawei RRU3928 1800MHz radio base station teardown (part 1 and 2)  (Read 578 times)

Offline Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1017
  • Karma: +16/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
The RRU3928 is an outdoor remote radio unit. It processes baseband and RF signal data. With the Software Defined Radio (SDR)technology, the RRU3928 supports the dual-mode operation of any two modes of GSM, UMTS, and LTE through software configuration modification. RRU3928 has a dual-transmitter and dual-receiver structure, which supports higher output power and carrier capacity.

It can f.ex. do 6x GSM carriers at each 10 Watt and 1x LTE carrier at 2x10 Watt or 4x GSM carrier at each 10 Watt and 2x UMTS carriers at 2x20 Watt.

This is the initial teardown and later on I will release part 2 which is the circuit analysis video.

« Last Edit: January 08, 2019, 08:25:55 AM by Mads Barnkob »
http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics

Offline Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1017
  • Karma: +16/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
Re: Huawei RRU3928 1800MHz radio base station teardown (part 1 of 2)
« Reply #1 on: January 08, 2019, 08:25:08 AM »
/>


Above pictures shows the coaxial cavity band pass filter which in popular speech is called a duplexer or diplexer. Duplexer band pass filter explained: https://www.youtube.com/watch?v=HNaAQ3a7Duc



The power amplifier consists of a series of low noise amplifiers, general purpose amplifiers and power amplifiers. The first amplifier IC is not able to be identified. First identifiable IC is a NXP BLF6G22LS-40P 1.8-2.1 GHz 5-15 Watt dual amplifier that feeds the Infineon PTFB182012FC which is a dual power amplifier rated for 2x 10 Watt dissipation at 1.8 GHz. Anaren Xinger 1P503S, Anaren Xinger II XC1900A-03S and Anaren Xinger III X3C19P1-05S hybrid and direct couplers are used. One output circulator is used for double protection against reflected energy from the duplexer and antenna array.



The system boards 4 ADC/DAC main processors are unknown HI FPGAs that has a generic part number which is not identifiable. A Altera Arria II GX EP2AGX260 FPGA seems to be the heart of the unit and does all system control and communication with other units of the system. It has 16 transceivers that can run up to 550 MHz. 102600 Adaptive Logic Modules and 244188 Logic Elements available.



The digital to analog signal path starts with one of the HI FPGA ICs that sends a single highspeed bitstream to the Analog Devices TxDAC AD9122. It is a dual 16-bit DAC with a capability of 1230 MSPS. Analog Devices ADF4902 PLL and Analog Devices ADL5372 1.5-2.5 GHz Quad Modulators seems to be the next part of the path before the output power adjusting TriQuint TQM879005A which is a 1.4-2.7 GHz Variable Gain Amplifier. It can adjust 0.5 dB amplification at a 6-bit scale input.



The analog to digital signal path starts with 6 NEDITEK NDF9117 1747.5 MHz SAW filters (explained here: https://youtu.be/qO127zY3voE?t=963 ) which feed into a Skyworks SKY64341-11 1.7-2.0 GHz RF frontend. This has by other parts a downconversion mixer (explained here: https://youtu.be/qO127zY3voE?t=865 ) which by the use of a local oscillator can bring down the carrier frequency of the signal to something lower that is easier to work with.

The two separate lines now go through the Analog Devices AD8376 dual Variable Gain Amplifiers that has a bandwidth of 700 MHz at -4dB to 20 dB. The last stage is the Texas Instruments ADS58C20 which is a dual IF multimode receiver capable of working with both GSM / 3G / LTE. If this is the final analog to digital conversion IC or it is one of the HI FPGAs is hard to tell.



Good power supply layout with a lot of transient protection at the input. A single full-bridge of PSMN4R8-100BSE 100V MOSFETs is used for first stage voltage stabilization before the smaller high current planar transformers are driven by D70N1045 MOSFETs.
http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics

High Voltage Forum

Re: Huawei RRU3928 1800MHz radio base station teardown (part 1 of 2)
« Reply #1 on: January 08, 2019, 08:25:08 AM »

 


* Recent Topics and Posts

post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
Bert911
Today at 04:58:39 PM
post Re: Static electricity measurement
[Static electricity]
Doros
Today at 01:56:17 PM
post Re: "LightningStorm" VTTC project
[Vacuum tube Tesla coils]
Avenger
Today at 01:28:59 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Patrick
Today at 12:47:16 AM
post SSTC interruptor not working
[Solid state Tesla coils]
juuzpo
June 23, 2019, 10:58:48 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Golddustpeak
June 23, 2019, 07:22:47 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Jeff B
June 23, 2019, 05:52:56 PM
post Re: Onetesla TS driver board for OWN coil need some help
[Dual Resonant Solid State Tesla coils]
dexter
June 23, 2019, 03:15:53 PM
post Onetesla TS driver board for OWN coil need some help
[Dual Resonant Solid State Tesla coils]
donnersm
June 23, 2019, 10:09:40 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Patrick
June 23, 2019, 10:07:04 AM
post Vacuum Epoxy Potting Attempt in Progress... (Pic Update 6/23/19)
[Transformer (ferrite core)]
Patrick
June 23, 2019, 08:50:14 AM
post Re: Si-wafers, ideas?
[Electronic circuits]
johnf
June 23, 2019, 01:28:20 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Twospoons
June 23, 2019, 01:17:50 AM
post Re: Si-wafers, ideas?
[Electronic circuits]
Twospoons
June 23, 2019, 01:04:13 AM
post Re: What happens when L and C are not matched?
[Electronic circuits]
Twospoons
June 23, 2019, 01:02:55 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Coupling
June 22, 2019, 11:10:02 PM
post Re: ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
flyrod
June 22, 2019, 08:45:17 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
flyrod
June 22, 2019, 08:36:34 PM
post Impressive 500,000 watt radio station from the 1930's
[Electronic circuits]
petespaco
June 22, 2019, 06:18:22 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
June 22, 2019, 05:47:22 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
T3sl4co1l
June 22, 2019, 05:21:58 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
June 22, 2019, 06:10:01 AM
post Re: Siemens Polyphos 30 xray machine
[X-ray]
Mads Barnkob
June 21, 2019, 09:08:16 AM
post Re: Choke-input DC-filter
[Electronic circuits]
johnf
June 20, 2019, 08:58:07 PM
post Re: CRT hacking ideas....
[Electronic circuits]
badpeter
June 20, 2019, 07:28:00 PM
post Re: Ideas needed!
[General chatting]
MRMILSTAR
June 20, 2019, 05:13:57 PM
post Re: Why did 4HV die??
[General chatting]
MRMILSTAR
June 20, 2019, 05:07:41 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
Bert911
June 20, 2019, 02:14:55 PM
post Re: Choke-input DC-filter
[Electronic circuits]
kamelryttarn
June 20, 2019, 12:53:58 PM
post Re: Choke-input DC-filter
[Electronic circuits]
johnf
June 20, 2019, 12:09:27 PM
post Choke-input DC-filter
[Electronic circuits]
kamelryttarn
June 20, 2019, 11:43:58 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
shrad
June 20, 2019, 08:57:42 AM
post Re: adventures in homemade flyback bobbins.
[Transformer (ferrite core)]
Patrick
June 20, 2019, 04:06:00 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
johnf
June 20, 2019, 03:50:56 AM
post Re: CRT hacking ideas....
[Electronic circuits]
petespaco
June 19, 2019, 11:29:28 PM
post Re: A dynamical arc model v2
[Dual Resonant Solid State Tesla coils]
Uspring
June 19, 2019, 01:40:16 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Mads Barnkob
June 19, 2019, 10:49:45 AM
post Re: A dynamical arc model v2
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
June 19, 2019, 10:43:32 AM
post Re: Light, laser and optics - Link collection
[Light, lasers and optics]
shrad
June 19, 2019, 10:03:54 AM
post Re: How go get single mode optic fiber to work
[Light, lasers and optics]
shrad
June 19, 2019, 10:02:21 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
shrad
June 19, 2019, 09:35:52 AM
post Re: CRT hacking ideas....
[Electronic circuits]
badpeter
June 18, 2019, 11:35:16 PM
post Re: CRT hacking ideas....
[Electronic circuits]
Mads Barnkob
June 18, 2019, 08:22:23 PM
post CRT hacking ideas....
[Electronic circuits]
badpeter
June 18, 2019, 07:20:16 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
VNTC
June 18, 2019, 12:16:43 PM
post Re: A dynamical arc model v2
[Dual Resonant Solid State Tesla coils]
Uspring
June 18, 2019, 11:45:53 AM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
Netzpfuscher
June 17, 2019, 09:01:29 PM
post Re: A dynamical arc model v2
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
June 17, 2019, 08:54:41 PM
post Re: Bought huge capacitors
[Capacitor banks]
MRMILSTAR
June 17, 2019, 04:34:02 PM
post Re: How energy flow through a DRSSTC?
[Dual Resonant Solid State Tesla coils]
Uspring
June 17, 2019, 03:13:03 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30