Author Topic: Nokia Siemens Flexi BTS base station teardown: Power amplifier (part 1 and 2)  (Read 689 times)

Offline Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1048
  • Karma: +16/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
/>
Teardown of a Nokia Siemens Networks Flexi BTS base station. This have been in service as a 6 antenna GSM system for mobile telecommunications.

GSM/EDGE, WCDMA/HSPA and LTE capable. 2x40 Watt output power.

also a picture of me pointing at where a remote radio unit or base station amplifier is usually mounted. Technically seen this is a TMA (tower mounted amplifier)

« Last Edit: November 22, 2018, 10:01:47 PM by Mads Barnkob »
http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics

Offline Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1048
  • Karma: +16/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
/>
Circuit analysis of a Nokia Siemens Networks Flexi BTS base station. This have been in service as a 6 antenna GSM system for mobile telecommunications.

GSM/EDGE, WCDMA/HSPA and LTE capable. 2x40 Watt output power.

If you missed part 1, see it here: http://kaizerpowerelectronics.dk/teardown/nokia-siemens-flexi-bts-base-station-teardown-power-amplifier-part-1-of-2/



Above picture shows the coaxial cavity band pass filter which in popular speech is called a duplexer or diplexer. For a explanation on how this works, watch the first part of the video shown here above.



The duplexer control board and front end is managed by a ARM7 TDMI microcontroller with part number TMS470R1A288PGET. It is a 32-bit 24 MHz RISC processor.

Anaren Xinger II XC1900E hybrid couplers are used for phase split before feeding into the low noise amplifiers for signal transfer from duplexer module to power amplifier module.



The last picture could possibly show the DAC used for the transmit chain. It is a TI DAC56721 which is a 14-bit DAC capable of 275 MSPS.

The power amplifier consists of a series of low noise amplifiers, general purpose amplifiers and power amplifiers. The first few amplifier ICs are not able to be identified as their part numbers are not unique.

First identifiable IC is a Freescale M005N 0.8-2.2 GHz 18.5 dB general purpose amplifier that feeds the Freescale SW7IC18100N which is a power amplifier rated for 100 Watt dissipate at 1.8 GHz.

Two output circulators is used for double protection against reflected energy from the duplexer and antenna array.



The system board main processor is a unknown TI FPGA that has a generic Nokia Siemens part number which is not identifiable. It has a Marvell Alaska 88E1111 Gigabit network controller to handle the optical network interfaces.

A Texas Instruments TI DSP IC could be used for the first stage digital to analog conversion, purely guessed on from its location on the PCB. It is the TMS320TCI100 (C64x series) with is running at 720 MHz and is able of running 5760 MIPS.



The analog to digital signal path starts with a ceramic resonator band pass filter (explained here:
) which feed into a Maxim MAX19995 dual 1.7-2.2 GHz downconversion mixer (explained here:
) which by the use of a local oscillator can bring down the carrier frequency of the signal to something lower that is easier to work with.

The two separate lines now go through the ultra low loss 21 MHz band pass filters from Epcos. The B5221 is a 172.8 MHz SAW IF filter (explained here:
) before being fed into either a ADC or another mixer, the ST PARIS part is not identifiable.

The last stage is the Analog Devices AD9218 which is a dual 10-bit analog to digital conversion IC capable of 105 MSPS.
http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics

High Voltage Forum


 


* Recent Topics and Posts

post CM300 coil build questions
[Dual Resonant Solid State Tesla coils]
acobaugh
Today at 05:32:28 AM
post Re: Welcome new members, come say hello and tell a little about yourself :
[General chatting]
ElectroXa
July 20, 2019, 09:45:42 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
Bert911
July 19, 2019, 11:19:45 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
July 19, 2019, 03:36:44 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
DICKEYBIRD
July 19, 2019, 03:24:38 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
July 19, 2019, 02:23:29 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
DICKEYBIRD
July 19, 2019, 01:06:44 AM
post Re: Floppiclene! A Electronics Cleaning Relic of the Past.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Justin
July 18, 2019, 10:29:32 PM
post Re: Floppiclene! A Electronics Cleaning Relic of the Past.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
July 18, 2019, 08:52:35 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
July 18, 2019, 05:49:27 AM
post A new quick way to get into tune a DRSSTC
[Dual Resonant Solid State Tesla coils]
VNTC
July 18, 2019, 03:13:27 AM
post Re: Floppiclene! A Electronics Cleaning Relic of the Past.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Twospoons
July 18, 2019, 12:06:53 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
July 17, 2019, 07:56:41 PM
post Floppiclene! A Electronics Cleaning Relic of the Past.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
July 17, 2019, 11:25:22 AM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
Netzpfuscher
July 16, 2019, 07:39:33 AM
post Re: What is the true in tuning guide?
[Dual Resonant Solid State Tesla coils]
VNTC
July 16, 2019, 05:11:21 AM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
profdc9
July 16, 2019, 04:05:07 AM
post Re: DRSSTC in brust mode
[Dual Resonant Solid State Tesla coils]
SAMGO
July 16, 2019, 02:25:27 AM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
Hydron
July 16, 2019, 01:54:30 AM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 15, 2019, 02:51:26 PM
post Re: What is the true in tuning guide?
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 15, 2019, 02:48:02 PM
post Re: A problem solved with hand tools
[General chatting]
Mads Barnkob
July 15, 2019, 01:48:08 PM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 15, 2019, 01:45:00 PM
post Re: A problem solved with hand tools
[General chatting]
Hydron
July 15, 2019, 11:21:29 AM
post What is the true in tuning guide?
[Dual Resonant Solid State Tesla coils]
VNTC
July 15, 2019, 10:01:21 AM
post A problem solved with hand tools
[General chatting]
klugesmith
July 15, 2019, 07:52:41 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
klugesmith
July 15, 2019, 07:33:30 AM
post Re: tesla coil varnish is dumb
[Solid state Tesla coils]
Hydron
July 14, 2019, 10:49:03 PM
post Re: tesla coil varnish is dumb
[Solid state Tesla coils]
T3sl4co1l
July 14, 2019, 09:59:40 PM
post Re: tesla coil varnish is dumb
[Solid state Tesla coils]
Mads Barnkob
July 14, 2019, 08:20:52 PM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils]
Netzpfuscher
July 14, 2019, 06:06:30 PM
post tesla coil varnish is dumb
[Solid state Tesla coils]
Fumeaux
July 14, 2019, 05:29:10 PM
post Led Closeups with Mobile phone and lens .
[Smart phones]
DashApple
July 14, 2019, 03:00:09 PM
post Re: Drsstc 3
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 14, 2019, 02:06:26 PM
post Re: DRSSTC in brust mode
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 14, 2019, 02:04:22 PM
post Re: Twin System Build
[Dual Resonant Solid State Tesla coils]
oneKone
July 14, 2019, 01:27:18 AM
post Re: DRSSTC in brust mode
[Dual Resonant Solid State Tesla coils]
johnf
July 14, 2019, 01:22:15 AM
post Re: Drsstc 3
[Dual Resonant Solid State Tesla coils]
oneKone
July 13, 2019, 03:48:54 PM
post DRSSTC in brust mode
[Dual Resonant Solid State Tesla coils]
SAMGO
July 13, 2019, 04:17:55 AM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
donnersm
July 12, 2019, 08:54:54 PM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
profdc9
July 12, 2019, 07:16:40 PM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
profdc9
July 12, 2019, 06:33:00 PM
post Smooth corona or heavy spark, RF wave radiation frequency of Tesla coil drops ve
[Dual Resonant Solid State Tesla coils]
VNTC
July 12, 2019, 11:09:28 AM
post Re: Drsstc 3
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 12, 2019, 09:56:38 AM
post Re: Drsstc 3
[Dual Resonant Solid State Tesla coils]
oneKone
July 12, 2019, 01:23:58 AM
post Re: Completed my pulsed power generator
[Capacitor banks]
MRMILSTAR
July 11, 2019, 05:48:27 PM
post Re: Completed my pulsed power generator
[Capacitor banks]
Mads Barnkob
July 11, 2019, 02:58:13 PM
post Re: Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
July 11, 2019, 02:45:24 PM
post Kaizer half bridge driver
[Dual Resonant Solid State Tesla coils]
donnersm
July 11, 2019, 06:59:01 AM
post Completed my pulsed power generator
[Capacitor banks]
MRMILSTAR
July 11, 2019, 05:43:31 AM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30