Author Topic: Kone Elevator Drive / Teardown, IGBT test, failure analysis  (Read 312 times)

Offline station240

  • High Voltage Enthusiast
  • *
  • Posts: 7
  • Karma: +1/-0
    • View Profile
Kone Elevator Drive / Teardown, IGBT test, failure analysis
« on: October 16, 2018, 08:48:54 AM »
Posted a link to this on EEVBlog forum, forgot to post it here too.

Found this video from Kevin Gittemeier
Yes the magic smoke did escape, from several places.
Rather interesting how cheaply made an elevator drive VFD can be.

Offline Mads Barnkob

  • Administrator
  • High Voltage Senior
  • *****
  • Posts: 985
  • Karma: +15/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
Re: Kone Elevator Drive / Teardown, IGBT test, failure analysis
« Reply #1 on: October 16, 2018, 11:03:39 PM »
I also did a teardown of a Kone elevator VFD and it seems to be the exact same unit, except mine was older.

Technological advances especially in the silicon / integrated 3 phase IGBT bricks made all these "small" drives very cheap to produce, there is no longer any real expensive parts to hold back a design or race it to the sky in price, at least not for consumer products, which a small elevator falls under in my view.

http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics

High Voltage Forum

Re: Kone Elevator Drive / Teardown, IGBT test, failure analysis
« Reply #1 on: October 16, 2018, 11:03:39 PM »

 


* Recent Topics and Posts

post Re: Offgrid 48V solar to 24V battery setup
[Electronic circuits]
Mads Barnkob
Today at 11:24:46 AM
post Re: ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
flyrod
Today at 03:22:54 AM
post Re: Are bleeder resistors necessary if I can easily discharge my capacitor?
[Spark gap Tesla coils]
profdc9
Today at 03:18:52 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
May 18, 2019, 10:48:59 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Golddustpeak
May 18, 2019, 04:19:11 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
May 17, 2019, 10:57:17 PM
post Are bleeder resistors necessary if I can easily discharge my capacitor?
[Spark gap Tesla coils]
jpb133
May 17, 2019, 09:41:56 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Uspring
May 17, 2019, 12:41:17 PM
post ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
82026
May 16, 2019, 04:15:58 PM
post Re: Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Fumeaux
May 16, 2019, 02:19:39 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Golddustpeak
May 16, 2019, 01:50:44 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Uspring
May 16, 2019, 12:17:01 PM
post Re: Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Fumeaux
May 16, 2019, 08:45:15 AM
post Re: Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
May 15, 2019, 11:49:59 PM
post Re: Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Hydron
May 15, 2019, 10:51:33 PM
post Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
May 15, 2019, 09:35:41 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Golddustpeak
May 15, 2019, 05:07:20 PM
post Re: Mounting LCD CFL's around DRSSTC?
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
May 15, 2019, 12:46:33 PM
post Re: General Oscilloscope Probing Techniques for (DR)SSTC h-bridge
[Beginners]
Mads Barnkob
May 15, 2019, 10:08:11 AM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
May 15, 2019, 10:04:59 AM
post General Oscilloscope Probing Techniques for (DR)SSTC h-bridge
[Beginners]
L_Mangold
May 15, 2019, 12:42:46 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
May 14, 2019, 11:28:43 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
badpeter
May 14, 2019, 09:58:28 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
May 14, 2019, 08:35:28 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
badpeter
May 14, 2019, 07:41:48 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
May 14, 2019, 06:05:25 PM
post Is one of these good?
[Dual Resonant Solid State Tesla coils]
Golddustpeak
May 14, 2019, 04:21:07 PM
post Re: X ray Transformer Offer
[X-ray]
Mads Barnkob
May 14, 2019, 02:20:27 PM
post Re: One model of L2 can run at several different frequencies. But which is the best?
[Dual Resonant Solid State Tesla coils]
Uspring
May 14, 2019, 12:58:30 PM
post Re: Gate Resistor Calculation
[Dual Resonant Solid State Tesla coils]
coil1002
May 14, 2019, 06:35:32 AM
post Re: One model of L2 can run at several different frequencies. But which is the best?
[Dual Resonant Solid State Tesla coils]
VNTC
May 14, 2019, 01:20:37 AM
post Mounting LCD CFL's around DRSSTC?
[Dual Resonant Solid State Tesla coils]
fafler
May 13, 2019, 07:58:25 PM
post Re: One model of L2 can run at several different frequencies. But which is the best?
[Dual Resonant Solid State Tesla coils]
Uspring
May 13, 2019, 03:24:34 PM
post Re: Just how large?
[Dual Resonant Solid State Tesla coils]
Fumeaux
May 13, 2019, 03:17:50 PM
post Just how large?
[Dual Resonant Solid State Tesla coils]
Golddustpeak
May 13, 2019, 03:04:50 PM
post Re: Gate Resistor Calculation
[Dual Resonant Solid State Tesla coils]
Hydron
May 13, 2019, 11:17:38 AM
post Re: One model of L2 can run at several different frequencies. But which is the best?
[Dual Resonant Solid State Tesla coils]
VNTC
May 13, 2019, 04:45:13 AM
post X ray Transformer Offer
[X-ray]
Joshua Guertler
May 13, 2019, 04:08:13 AM
post Re: Gate Resistor Calculation
[Dual Resonant Solid State Tesla coils]
profdc9
May 13, 2019, 03:05:03 AM
post Re: Gate Resistor Calculation
[Dual Resonant Solid State Tesla coils]
coil1002
May 13, 2019, 01:49:00 AM
post Re: Gate Resistor Calculation
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
May 12, 2019, 10:17:22 PM
post Re: My first DRSSTC on bricks
[Dual Resonant Solid State Tesla coils]
Laci
May 12, 2019, 09:49:02 PM
post Re: Gate Resistor Calculation
[Dual Resonant Solid State Tesla coils]
Uspring
May 12, 2019, 06:42:53 PM
post Re: Gate Resistor Calculation
[Dual Resonant Solid State Tesla coils]
profdc9
May 12, 2019, 05:41:02 PM
post Re: One model of L2 can run at several different frequencies. But which is the best?
[Dual Resonant Solid State Tesla coils]
Uspring
May 12, 2019, 03:38:12 PM
post Re: One model of L2 can run at several different frequencies. But which is the best?
[Dual Resonant Solid State Tesla coils]
VNTC
May 12, 2019, 03:17:01 AM
post Gate Resistor Calculation
[Dual Resonant Solid State Tesla coils]
coil1002
May 12, 2019, 02:50:11 AM
post Re: adventures in homemade flyback bobbins.
[Transformer (ferrite core)]
dexter
May 12, 2019, 12:40:56 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
May 12, 2019, 12:18:58 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
Mads Barnkob
May 11, 2019, 08:34:31 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30