Author Topic: No sparks at the rotating spark gap  (Read 620 times)

Offline AndreiRS

  • High Voltage Experimenter
  • **
  • Posts: 69
  • Karma: +0/-0
    • View Profile
No sparks at the rotating spark gap
« on: February 26, 2018, 11:00:52 PM »
I was using microwave oven capacitors for my primary "MMC", but a lot of people said they are not good for this high frequency purpose. So I made 2 capacitors with pvc pipe and end caps. Both are 50mm or 2" wide and around 50cm long, or around 20". Each one gives me 215nF. So I connected them in series and now I have 107nF and double voltage rating.

Tesla Map says I need 19.2nF for ressonance with the transformer, which we don't want, 31.1nF for larger than ressonance stactic gap and 50.1nF for rotary. But then again, mine is 107. I'm not sure if a capacitor way bigger than needed would make things not work at all. When I turn it on, I can clearly hear the transformer at full power let's say. But I only got 1 spark at the gap, after 2-3 seconds waiting.
« Last Edit: February 26, 2018, 11:02:56 PM by AndreiRS »

High Voltage Forum

No sparks at the rotating spark gap
« on: February 26, 2018, 11:00:52 PM »

 


* Recent Topics and Posts

post Re: CW multiplier resistor string suggestions
[Voltage Multipliers]
davekni
Today at 06:50:11 AM
post Re: CW multiplier resistor string suggestions
[Voltage Multipliers]
plasma
Today at 12:00:00 AM
post CW multiplier resistor string suggestions
[Voltage Multipliers]
MRMILSTAR
December 07, 2019, 11:32:49 PM
post Re: Sense coil fabrication?
[Induction launchers, coil guns and rails guns]
klugesmith
December 07, 2019, 09:54:31 PM
post Re: SGTC MK1 - An Accomplishment in Progress
[Spark gap Tesla coils]
jturnerkc
December 07, 2019, 09:48:21 PM
post Re: Sense coil fabrication?
[Induction launchers, coil guns and rails guns]
klugesmith
December 07, 2019, 08:59:57 PM
post Re: Cost reduction in consumer electrics
[Electronic circuits]
MRMILSTAR
December 06, 2019, 08:35:29 PM
post Re: Full bridge showing half the voltage
[Beginners]
plasma
December 06, 2019, 05:19:26 AM
post Re: Cost reduction in consumer electrics
[Electronic circuits]
davekni
December 06, 2019, 03:48:34 AM
post Re: Cost reduction in consumer electrics
[Electronic circuits]
the_anomaly
December 06, 2019, 03:35:39 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
AstRii
December 06, 2019, 01:27:03 AM
post Re: Full bridge showing half the voltage
[Beginners]
plasma
December 05, 2019, 11:38:59 PM
post Re: Cost reduction in consumer electrics
[Electronic circuits]
Mads Barnkob
December 05, 2019, 07:33:01 PM
post Re: Cost reduction in consumer electrics
[Electronic circuits]
sjsimmo
December 05, 2019, 11:09:20 AM
post Cost reduction in consumer electrics
[Electronic circuits]
klugesmith
December 05, 2019, 07:25:20 AM
post Re: HV resistor in oil
[Voltage Multipliers]
MRMILSTAR
December 05, 2019, 05:52:11 AM
post Re: HV resistor in oil
[Voltage Multipliers]
davekni
December 05, 2019, 05:21:07 AM
post Re: HV resistor in oil
[Voltage Multipliers]
MRMILSTAR
December 04, 2019, 06:05:11 PM
post Re: Full bridge showing half the voltage
[Beginners]
shrad
December 04, 2019, 02:57:02 PM
post Re: Sense coil fabrication?
[Induction launchers, coil guns and rails guns]
Uspring
December 04, 2019, 12:40:51 PM
post Re: Full bridge showing half the voltage
[Beginners]
plasma
December 04, 2019, 11:20:25 AM
post Re: Sense coil fabrication?
[Induction launchers, coil guns and rails guns]
klugesmith
December 04, 2019, 08:28:15 AM
post Re: Full bridge showing half the voltage
[Beginners]
klugesmith
December 04, 2019, 07:41:21 AM
post Re: Sense coil fabrication?
[Induction launchers, coil guns and rails guns]
MRMILSTAR
December 04, 2019, 05:15:49 AM
post Re: HV resistor in oil
[Voltage Multipliers]
MRMILSTAR
December 04, 2019, 05:06:39 AM
post Re: HV resistor in oil
[Voltage Multipliers]
davekni
December 04, 2019, 04:31:16 AM
post Re: Full bridge showing half the voltage
[Beginners]
davekni
December 04, 2019, 04:26:38 AM
post Re: Sense coil fabrication?
[Induction launchers, coil guns and rails guns]
klugesmith
December 04, 2019, 04:10:16 AM
post Re: Sense coil fabrication?
[Induction launchers, coil guns and rails guns]
klugesmith
December 04, 2019, 12:28:15 AM
post Re: Full bridge showing half the voltage
[Beginners]
plasma
December 04, 2019, 12:11:32 AM
post Re: HV resistor in oil
[Voltage Multipliers]
johnf
December 03, 2019, 07:58:41 PM
post Re: Driving Nixie-tubes with arduino
[Electronic circuits]
johnf
December 03, 2019, 07:54:08 PM
post Re: Full bridge showing half the voltage
[Beginners]
klugesmith
December 03, 2019, 07:41:00 PM
post Re: Driving Nixie-tubes with arduino
[Electronic circuits]
kamelryttarn
December 03, 2019, 02:14:00 PM
post Re: Driving Nixie-tubes with arduino
[Electronic circuits]
Mads Barnkob
December 03, 2019, 01:24:00 PM
post Re: Driving Nixie-tubes with arduino
[Electronic circuits]
klugesmith
December 03, 2019, 10:45:58 AM
post Driving Nixie-tubes with arduino
[Electronic circuits]
kamelryttarn
December 03, 2019, 09:04:42 AM
post Re: Full bridge showing half the voltage
[Beginners]
plasma
December 03, 2019, 07:29:48 AM
post Re: HV resistor in oil
[Voltage Multipliers]
MRMILSTAR
December 03, 2019, 05:07:28 AM
post Re: HV resistor in oil
[Voltage Multipliers]
davekni
December 03, 2019, 04:34:46 AM
post Re: HV resistor in oil
[Voltage Multipliers]
MRMILSTAR
December 02, 2019, 09:06:07 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
T3sl4co1l
December 02, 2019, 10:51:33 AM
post Re: SGTC MK1 - An Accomplishment in Progress
[Spark gap Tesla coils]
jturnerkc
December 02, 2019, 05:49:05 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
December 02, 2019, 04:10:14 AM
post Re: SGTC MK1 - An Accomplishment in Progress
[Spark gap Tesla coils]
davekni
December 02, 2019, 04:09:37 AM
post Re: HV resistor in oil
[Voltage Multipliers]
davekni
December 02, 2019, 03:42:16 AM
post Re: HV resistor in oil
[Voltage Multipliers]
MRMILSTAR
December 01, 2019, 10:47:18 PM
post Re: HV resistor in oil
[Voltage Multipliers]
Mads Barnkob
December 01, 2019, 09:17:38 PM
post HV resistor in oil
[Voltage Multipliers]
MRMILSTAR
December 01, 2019, 08:51:31 PM
post Re: SGTC MK1 - An Accomplishment in Progress
[Spark gap Tesla coils]
jturnerkc
December 01, 2019, 07:32:44 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30