Author Topic: Do you need a power line filter?  (Read 1009 times)

Offline FilipŠebík

  • High Voltage Enthusiast
  • *
  • Posts: 28
  • Karma: +0/-0
    • View Profile
Do you need a power line filter?
« on: January 06, 2018, 07:44:39 PM »
Hey, I just built this tesla coil http://kaizerpowerelectronics.dk/tesla-coils/kaizer-sstc-ii/ and I only powered it from 12V which gave me no sparks at all, just to tune it. Now I want to know if I need a line filter to power the primary from a transformer or mains and what would happen if I didn't use it. Thanks for the help

Offline Mads Barnkob

  • Administrator
  • High Voltage Senior
  • *****
  • Posts: 920
  • Karma: +11/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
Re: Do you need a power line filter?
« Reply #1 on: January 06, 2018, 08:14:42 PM »
Hi Filip and welcome to HVF!

For small coils like my SSTC's and the DRSSTC2, I would use mains filters that you can salvage from various consumer electronics.

When we start talking larger Tesla coils I have run them without, but that is also outside of buildings with a dedicated RF ground.

We do like to prevent as much noise as possible to run backwards into the mains supply, to protect the other electronic equipment in your house. The most important part of the line filter in regard to Tesla coils is the Y capacitors as they couple the line and neutral to the ground, around 10 nF is suitable if you are building it yourself.

http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics

Offline FilipŠebík

  • High Voltage Enthusiast
  • *
  • Posts: 28
  • Karma: +0/-0
    • View Profile
Re: Do you need a power line filter?
« Reply #2 on: January 06, 2018, 08:24:32 PM »
So I can use ATX power supply filter? If that's it, then thanks

EDIT: Should I use it on mains input to transformer or low voltage transformer output?
« Last Edit: January 06, 2018, 08:28:00 PM by FilipŠebík »

Offline Mads Barnkob

  • Administrator
  • High Voltage Senior
  • *****
  • Posts: 920
  • Karma: +11/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
Re: Do you need a power line filter?
« Reply #3 on: January 06, 2018, 10:26:49 PM »
So I can use ATX power supply filter? If that's it, then thanks

EDIT: Should I use it on mains input to transformer or low voltage transformer output?

Yes you can use one from a ATX power supply, if it is rated for a high enough current. The filter should always be used on the mains supply side, so that would be the primary side of your transformer.
http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics

Offline FilipŠebík

  • High Voltage Enthusiast
  • *
  • Posts: 28
  • Karma: +0/-0
    • View Profile
Re: Do you need a power line filter?
« Reply #4 on: January 07, 2018, 07:14:54 AM »
Nice, thanks for help

High Voltage Forum

Re: Do you need a power line filter?
« Reply #4 on: January 07, 2018, 07:14:54 AM »

 


* Recent Topics and Posts

post Re: Keep or throw away ?
[Beginners]
Thunderstruck
March 19, 2019, 10:02:41 PM
post Re: Keep or throw away ?
[Beginners]
Hydron
March 19, 2019, 08:14:33 PM
post Re: Keep or throw away ?
[Beginners]
Teravolt
March 19, 2019, 05:12:03 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Experimentonomen
March 19, 2019, 01:32:32 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Mads Barnkob
March 19, 2019, 12:20:34 PM
post Re: Strange gdt waveforms
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
March 19, 2019, 12:15:22 PM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
Mads Barnkob
March 19, 2019, 10:46:50 AM
post Re: Keep or throw away ?
[Beginners]
Thunderstruck
March 19, 2019, 09:11:09 AM
post Re: Keep or throw away ?
[Beginners]
Mads Barnkob
March 19, 2019, 08:24:31 AM
post Re: Keep or throw away ?
[Beginners]
Teravolt
March 19, 2019, 01:51:51 AM
post Re: Keep or throw away ?
[Beginners]
Thunderstruck
March 18, 2019, 09:56:42 PM
post Re: cute-qcw Tesla Coil
[Dual Resonant Solid State Tesla coils]
Weston
March 18, 2019, 07:55:52 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
March 18, 2019, 06:11:07 PM
post Re: Strange gdt waveforms
[Dual Resonant Solid State Tesla coils]
Hydron
March 18, 2019, 02:27:35 PM
post Re: cute-qcw Tesla Coil
[Dual Resonant Solid State Tesla coils]
Uspring
March 18, 2019, 12:52:35 PM
post Re: Strange gdt waveforms
[Dual Resonant Solid State Tesla coils]
FilipŠebík
March 18, 2019, 12:22:58 PM
post New small SSTC
[Solid state Tesla coils]
Bambinz
March 18, 2019, 11:46:18 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Bambinz
March 18, 2019, 11:29:02 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
Mads Barnkob
March 18, 2019, 10:35:04 AM
post Re: Strange gdt waveforms
[Dual Resonant Solid State Tesla coils]
Marty
March 18, 2019, 05:32:43 AM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
Experimentonomen
March 17, 2019, 09:13:47 PM
post Re: DRSSTC Driver Logic
[Dual Resonant Solid State Tesla coils]
Netzpfuscher
March 17, 2019, 04:08:33 PM
post Re: WTB: Large Heatsink with a Baseplate at least 10mm thick
[Sell / Buy / Trade]
Phoenix
March 17, 2019, 02:46:44 PM
post Re: cute-qcw Tesla Coil
[Dual Resonant Solid State Tesla coils]
flyglas
March 17, 2019, 02:21:45 PM
post Re: DRSSTC Driver Logic
[Dual Resonant Solid State Tesla coils]
Laci
March 17, 2019, 01:54:47 PM
post Re: WTB: Large Heatsink with a Baseplate at least 10mm thick
[Sell / Buy / Trade]
Mads Barnkob
March 17, 2019, 10:15:16 AM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
FilipŠebík
March 17, 2019, 09:33:50 AM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
Teravolt
March 17, 2019, 05:32:48 AM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
Thunderstruck
March 17, 2019, 02:39:25 AM
post WTB: Large Heatsink with a Baseplate at least 10mm thick
[Sell / Buy / Trade]
Phoenix
March 16, 2019, 10:06:39 PM
post Re: Large Ferrite Core with IGBT-Brick Driver
[Transformer (ferrite core)]
rikkitikkitavi
March 16, 2019, 08:35:51 PM
post Re: cute-qcw Tesla Coil
[Dual Resonant Solid State Tesla coils]
Weston
March 16, 2019, 08:04:52 PM
post Re: cute-qcw Tesla Coil
[Dual Resonant Solid State Tesla coils]
flyglas
March 16, 2019, 06:44:14 PM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
FilipŠebík
March 16, 2019, 09:57:55 AM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
Thunderstruck
March 16, 2019, 09:40:55 AM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
FilipŠebík
March 16, 2019, 08:57:54 AM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
Thunderstruck
March 16, 2019, 08:46:24 AM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
FilipŠebík
March 16, 2019, 08:27:24 AM
post Re: UD 2.7C Build
[Dual Resonant Solid State Tesla coils]
Thunderstruck
March 16, 2019, 07:35:58 AM
post GDT Experiments
[Solid state Tesla coils]
Thunderstruck
March 16, 2019, 06:32:36 AM
post cute-qcw Tesla Coil
[Dual Resonant Solid State Tesla coils]
Weston
March 16, 2019, 06:01:44 AM
post Re: Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
Thunderstruck
March 16, 2019, 05:46:38 AM
post Which varnish to use to coat the Secondary?
[Solid state Tesla coils]
FilipŠebík
March 15, 2019, 10:11:53 PM
post Re: Large Ferrite Core with IGBT-Brick Driver
[Transformer (ferrite core)]
Mads Barnkob
March 15, 2019, 10:31:10 AM
post Re: Mechanical QCW !!
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
March 15, 2019, 09:44:59 AM
post Re: Large Ferrite Core with IGBT-Brick Driver
[Transformer (ferrite core)]
Hydron
March 15, 2019, 09:27:48 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
Mads Barnkob
March 15, 2019, 08:49:01 AM
post Mechanical QCW !!
[Dual Resonant Solid State Tesla coils]
pentode
March 15, 2019, 08:33:23 AM
post Re: Piernas's Fast ZVS Mazzilli Driver
[Transformer (ferrite core)]
neukyhm
March 14, 2019, 11:30:12 PM
post Re: Large Ferrite Core with IGBT-Brick Driver
[Transformer (ferrite core)]
Phoenix
March 14, 2019, 11:18:04 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30