Author Topic: Ring launcher to coil gun conversion  (Read 520 times)

Offline DrewScott

  • High Voltage Enthusiast
  • *
  • Posts: 8
  • Karma: +0/-0
    • View Profile
Ring launcher to coil gun conversion
« on: January 12, 2021, 12:33:54 AM »
I have a 0.7kJ ring launcher that will launch a copper ring hard enough to put a dent in the ceiling. It uses a pancake work coil that has about 8 turns. I wound a tube type coil with many more turns (I haven't counted but probably close to 100) since the two devices work on different principles. The ring launcher induces a current and magnetic field in the copper ring which repels the magnetic field of the coil. For the coil gun, the projectile has to be magnetized and pulled toward the center of the coil, and has a greater mass. My thinking was that I would need more turns on the work coil for the coil gun, but it will hardly move the projectile. Do I just have way too many turns and too high impedance on the tube coil? Is that the problem? The ring launcher is very powerful. I would like to make the coil gun just as stout.

Offline davekni

  • High Voltage Senior
  • *****
  • Posts: 978
  • Karma: +42/-0
  • Physicist, engineer (electronic), and hobbiest
    • View Profile
Re: Ring launcher to coil gun conversion
« Reply #1 on: January 12, 2021, 01:12:14 AM »
MUCH more information would be necessary to make any useful comment.  You could copy a successful design.  Or you could take the longer and more interesting and educational route of designing your own.  It will require experiments and ideally simulation and modeling - at least some crude calculations.

At high accelerations, conductive (ie. copper or aluminum) projectiles such as your ring are more efficient than soft magnetic projectiles such as steel.  Steel saturates a bit under 2Teslas (20000 Gauss).  For short pulses, copper can repel much higher fields.  On the other hand, at lower accelerations, steel can be more efficient.
David Knierim

Offline klugesmith

  • High Voltage Engineer
  • ****
  • Posts: 340
  • Karma: +8/-0
    • View Profile
Re: Ring launcher to coil gun conversion
« Reply #2 on: January 13, 2021, 12:37:06 AM »
Good that you're trying to be engineer-ish about it, Drew.  There's a wealth of information about coilguns at this forum and others.  Just confirmed that https://www.coilgun.info still exists.

Remember that ring launchers and coil guns are not just about throwing electrical joules at the system.  I made that point to young Adam Munich about 10 years ago on 4hv, after fabricating some copper wedges for him to try in a contactor.  Design efficiency is sensitive to the length of current pulse, compared to the time scale with which coil-projectile geometry changes.  That makes it a nonlinear system, so efficiency with fully charged capacitor can be very different (in either direction) from that with partly charged capacitor.

For a given work coil size and mass, you can control the RLC discharge timing over a wide range
by choice of wire diameter -> number of turns to fill the bobbin -> coil inductance -> discharge time.
There's no general rule about more or less turns working better.  (Just as optimum grain size for gunpowder depends on the chamber, projectile, and gun barrel.)

A turns-optimized bigger & heavier coil can often do better than a turns-optimized smaller & lighter coil.  Less resistance for any given inductance, but that can eventually lead to underdamped discharges.
« Last Edit: January 13, 2021, 12:54:44 AM by klugesmith »

Offline DrewScott

  • High Voltage Enthusiast
  • *
  • Posts: 8
  • Karma: +0/-0
    • View Profile
Re: Ring launcher to coil gun conversion
« Reply #3 on: January 14, 2021, 03:13:36 AM »
Thank you all for the info! Sounds like I have a lot more to investigate.

High Voltage Forum

Re: Ring launcher to coil gun conversion
« Reply #3 on: January 14, 2021, 03:13:36 AM »

 


* Recent Topics and Posts

post Re: DRSSTC Performs only with 1cm Arcs - Troubleshooting
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
Today at 05:08:32 AM
post Re: Project: FreakyDRSSTC MK1
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
Today at 04:47:32 AM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 03, 2021, 11:20:38 PM
post Re: Next Gen DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
AeraCura_
March 03, 2021, 11:15:32 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
Twospoons
March 03, 2021, 10:30:40 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 03, 2021, 10:03:26 PM
post Re: Need Help w/Build - Lightning Pulse Generator
[Laboratories, Equipment and Tools]
Mads Barnkob
March 03, 2021, 09:45:28 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
Twospoons
March 03, 2021, 09:44:17 PM
post First power on tests
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GrantV
March 03, 2021, 06:26:23 PM
post Re: Search for opinions concerning the use or test of a yunbao / Ebay drsstc skp
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GrantV
March 03, 2021, 05:54:58 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 03, 2021, 03:13:30 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 03, 2021, 01:18:22 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 03, 2021, 12:25:52 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 03, 2021, 12:24:40 PM
post Re: DRSSTC Performs only with 1cm Arcs - Troubleshooting
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ChrisBlis
March 03, 2021, 10:43:20 AM
post Re: Search for opinions concerning the use or test of a yunbao / Ebay drsstc skp
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GrantV
March 03, 2021, 09:05:02 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic Circuits]
davekni
March 03, 2021, 05:53:33 AM
post Re: Through-hole layout of UD2.7C universal driver
[Dual Resonant Solid State Tesla coils (DRSSTC)]
profdc9
March 03, 2021, 04:22:01 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic Circuits]
petespaco
March 03, 2021, 04:00:14 AM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
davekni
March 03, 2021, 01:21:15 AM
post Re: Just a noob with some HV concerns...
[Beginners]
AstRii
March 03, 2021, 12:36:05 AM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 03, 2021, 12:35:57 AM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
davekni
March 02, 2021, 11:40:16 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 02, 2021, 11:29:28 PM
post Re: DRSSTC Performs only with 1cm Arcs - Troubleshooting
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
March 02, 2021, 10:48:04 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
davekni
March 02, 2021, 10:33:13 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 02, 2021, 10:20:22 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic Circuits]
davekni
March 02, 2021, 10:18:05 PM
post Re: Search for opinions concerning the use or test of a yunbao / Ebay drsstc skp
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
March 02, 2021, 09:38:45 PM
post Re: Through-hole layout of UD2.7C universal driver
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Max
March 02, 2021, 08:54:33 PM
post Re: WTS [EU] Vici DM4070 LCR meter with SMD tweezers
[Sell / Buy / Trade]
Da_Stier
March 02, 2021, 08:53:31 PM
post Re: Through-hole layout of UD2.7C universal driver
[Dual Resonant Solid State Tesla coils (DRSSTC)]
profdc9
March 02, 2021, 05:04:44 PM
post Re: Search for opinions concerning the use or test of a yunbao / Ebay drsstc skp
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GrantV
March 02, 2021, 03:16:25 PM
post Re: WTS [EU] Vici DM4070 LCR meter with SMD tweezers
[Sell / Buy / Trade]
AstRii
March 02, 2021, 09:41:31 AM
post Re: DRSSTC Performs only with 1cm Arcs - Troubleshooting
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ChrisBlis
March 02, 2021, 08:26:30 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic Circuits]
hightemp1
March 02, 2021, 07:05:01 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic Circuits]
davekni
March 02, 2021, 06:22:52 AM
post Re: Interesting RF air-core transformer construction
[Vacuum Tube Tesla Coils (VTTC)]
MRMILSTAR
March 02, 2021, 05:24:46 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic Circuits]
hightemp1
March 02, 2021, 05:21:16 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic Circuits]
petespaco
March 02, 2021, 04:37:50 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic Circuits]
hightemp1
March 02, 2021, 01:26:36 AM
post Re: DRSSTC Performs only with 1cm Arcs - Troubleshooting
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
March 01, 2021, 11:07:01 PM
post Re: Very old flyback
[Transformer (Ferrite Core)]
Alberto
March 01, 2021, 11:04:06 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 01, 2021, 09:45:59 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
davekni
March 01, 2021, 09:30:44 PM
post Re: DRSSTC Performs only with 1cm Arcs - Troubleshooting
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ChrisBlis
March 01, 2021, 09:27:38 PM
post Re: Through-hole layout of UD2.7C universal driver
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Max
March 01, 2021, 09:05:02 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 01, 2021, 08:22:33 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
davekni
March 01, 2021, 08:16:46 PM
post Re: Baxandall converter strange output
[Transformer (Ferrite Core)]
dreamth
March 01, 2021, 07:39:33 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal