Author Topic: IGBT brick internal gate resistor power dissipation  (Read 218 times)

Offline davekni

  • High Voltage Senior
  • *****
  • Posts: 678
  • Karma: +33/-0
  • Physicist, engineer (electronic), and hobbiest
    • View Profile
IGBT brick internal gate resistor power dissipation
« on: October 26, 2020, 05:33:01 AM »
This may seem like a strange concern, but I'm wondering about the possibility of internal IGBT brick gate resistor failure.  I'm designing a QCW for long 100ms pulses starting around 170kHz.  Planning to use CM600DY-13T half-bridge bricks.  Internal gate resistance is 1-ohm, with recommended 1-ohm external.  Running +-20V gate drive into 6uC/gate at 170kHz is 41watts/gate or 82watts/brick.  With external 1-ohm, half that 82watts is external and half internal.  Thus the internal gate resistors are running at 41watts/brick.  If the internal gate resistors are thick-film and relatively small, I wonder about long-term failure.  Thick-film resistors don't survive power pulses very well.

For those of you who have deconstructed IGBT bricks:  How robust to the gate resistors appear?  Is it possible to determine resistor element technology (thin-film, thick-film, or wire-wound)?  Are the resistors thermally connected to the base, or suspended above?  Should I be concerned about 41 watts for a CM600DY-13T brick gate drive internal power?

Thank you all in advance for advice.
David Knierim

Offline Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1565
  • Karma: +28/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
Re: IGBT brick internal gate resistor power dissipation
« Reply #1 on: October 26, 2020, 08:23:48 PM »
I have never seen internal gate resistor that look like a regular resistor.

I have only seen integrated gate resistors that looks like underneath, small island pads with a thin outline to the underlaying layer.

http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics
https://www.youtube.com/KaizerPowerElectronicsDk60/join - Please consider supporting the forum, websites and youtube channel!

Offline davekni

  • High Voltage Senior
  • *****
  • Posts: 678
  • Karma: +33/-0
  • Physicist, engineer (electronic), and hobbiest
    • View Profile
Re: IGBT brick internal gate resistor power dissipation
« Reply #2 on: October 26, 2020, 09:43:44 PM »
Mads,

Thank you for the picture!  I can't tell what the resistor technology is.  It is nice to see that the resistors are on the heat-sink surface along with the IGBT die.  At least that helps with power dissipation.

Measuring Mads image, gate resistors account for about 2.2% of the total die area.  If I assume similar ratio for CM600DY-13T with total package power limit of 4000 watts, then gate resistors could dissipate 88 watts.  That is well more than the 41 watts I calculate for my QCW design.  Encouraging to know - indicates my gate resistor power concerns are low-risk.

Anyone have images that differ in resistor type/mounting from the image Mads posted?
« Last Edit: October 26, 2020, 10:07:11 PM by davekni »
David Knierim

Offline Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1565
  • Karma: +28/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
Re: IGBT brick internal gate resistor power dissipation
« Reply #3 on: October 26, 2020, 10:25:19 PM »
At bottom of page. Here you can clearly see that the bond wires are just jumping pad on to the gate in the middle of the islands (no internal gate resistor): http://kaizerpowerelectronics.dk/technology/teardown-schneider-electric-frequency-inverter-altivar71/

Built-in drivers sit on base plate: http://kaizerpowerelectronics.dk/teardown/3-phase-igbt-module-teardown-fuji-7mbp50ra120-from-3-kw-omron-servo-drive-isolation-day-36/

CM600 that I removed RTC from, same internal resistor pads can be seen at the bottom
/>
http://www.kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics
https://www.youtube.com/KaizerPowerElectronicsDk60/join - Please consider supporting the forum, websites and youtube channel!

High Voltage Forum

Re: IGBT brick internal gate resistor power dissipation
« Reply #3 on: October 26, 2020, 10:25:19 PM »

 


* Recent Topics and Posts

post Re: steam engine
[Capacitor Banks]
davekni
November 28, 2020, 11:56:04 PM
post Re: steam engine
[Capacitor Banks]
Twospoons
November 28, 2020, 11:03:54 PM
post Re: mini tesla (hopefully not a fail)
[Beginners]
davekni
November 28, 2020, 07:45:38 PM
post Re: Setting over current protection for my drsstc
[Dual Resonant Solid State Tesla coils (DRSSTC)]
octopus1
November 28, 2020, 06:54:18 PM
post Re: HF Litz wire as a primary coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Da_Stier
November 28, 2020, 06:32:22 PM
post Re: Ericsson RRUS 11 B4 teardown
[Radio Frequency]
Da_Stier
November 28, 2020, 06:29:37 PM
post Re: Setting over current protection for my drsstc
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Hydron
November 28, 2020, 06:22:11 PM
post Re: Setting over current protection for my drsstc
[Dual Resonant Solid State Tesla coils (DRSSTC)]
octopus1
November 28, 2020, 03:10:04 PM
post Re: Setting over current protection for my drsstc
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
November 28, 2020, 12:36:05 PM
post Re: mini tesla (hopefully not a fail)
[Beginners]
bogdan
November 28, 2020, 08:16:41 AM
post Re: steam engine
[Capacitor Banks]
davekni
November 28, 2020, 06:35:48 AM
post Re: mini tesla (hopefully not a fail)
[Beginners]
bogdan
November 28, 2020, 06:22:44 AM
post Re: steam engine
[Capacitor Banks]
Twospoons
November 28, 2020, 06:04:33 AM
post Re: steam engine
[Capacitor Banks]
plasma
November 28, 2020, 04:36:08 AM
post Setting over current protection for my drsstc
[Dual Resonant Solid State Tesla coils (DRSSTC)]
octopus1
November 28, 2020, 12:37:32 AM
post Re: Single mosfet driving with GDT
[Solid State Tesla Coils (SSTC)]
Magneticitist
November 27, 2020, 10:57:31 PM
post Re: Ericsson RRUS 11 B4 teardown
[Radio Frequency]
Mads Barnkob
November 27, 2020, 10:33:30 PM
post Re: Single mosfet driving with GDT
[Solid State Tesla Coils (SSTC)]
costas_p
November 27, 2020, 08:42:35 PM
post Re: Question about arduino polyphonic MIDI interrupter
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
November 27, 2020, 07:45:58 PM
post Re: mini tesla (hopefully not a fail)
[Beginners]
davekni
November 27, 2020, 07:35:55 PM
post Re: mini tesla (hopefully not a fail)
[Beginners]
bogdan
November 27, 2020, 05:09:54 PM
post Re: Question about arduino polyphonic MIDI interrupter
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Max
November 27, 2020, 01:45:04 PM
post Re: HF Litz wire as a primary coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
November 27, 2020, 02:18:49 AM
post Re: compact midi interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
TMaxElectronics
November 27, 2020, 01:17:40 AM
post HF Litz wire as a primary coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
TMaxElectronics
November 27, 2020, 12:33:29 AM
post Re: Question about arduino polyphonic MIDI interrupter
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
November 26, 2020, 07:28:57 PM
post Re: Question about arduino polyphonic MIDI interrupter
[Dual Resonant Solid State Tesla coils (DRSSTC)]
bozidar
November 26, 2020, 07:20:41 PM
post Re: QCW with replaceable ferrite-core primary
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
November 26, 2020, 06:48:34 PM
post Re: Question about arduino polyphonic MIDI interrupter
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Max
November 26, 2020, 02:42:34 PM
post Re: Question about arduino polyphonic MIDI interrupter
[Dual Resonant Solid State Tesla coils (DRSSTC)]
TMaxElectronics
November 26, 2020, 01:22:02 PM
post Question about arduino polyphonic MIDI interrupter
[Dual Resonant Solid State Tesla coils (DRSSTC)]
bozidar
November 26, 2020, 01:09:32 PM
post Re: AGFA ADC 5155 X-ray Scanner Teardown (4 part series)
[X-ray]
Mads Barnkob
November 26, 2020, 12:27:05 PM
post Re: QCW with replaceable ferrite-core primary
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Uspring
November 26, 2020, 12:07:11 PM
post Current transformer for measuring primary current
[Dual Resonant Solid State Tesla coils (DRSSTC)]
octopus1
November 26, 2020, 01:32:17 AM
post Re: SSTC issues (gate signal, interrupter-mode, grounding)
[Solid State Tesla Coils (SSTC)]
davekni
November 25, 2020, 09:57:26 PM
post Re: Polyphonic Interrupter with STM32F103C8T6 (Bluepill)
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Zipdox
November 25, 2020, 09:13:24 PM
post Re: SSTC issues (gate signal, interrupter-mode, grounding)
[Solid State Tesla Coils (SSTC)]
Max Seiringer
November 25, 2020, 09:01:22 PM
post Re: Slayer Exciter Mosfet Gate drive alternative?
[Solid State Tesla Coils (SSTC)]
Magneticitist
November 25, 2020, 07:13:17 PM
post Re: Ericsson RRUS 11 B4 teardown
[Radio Frequency]
Da_Stier
November 25, 2020, 05:21:28 PM
post Ericsson RRUS 11 B4 teardown
[Radio Frequency]
Da_Stier
November 25, 2020, 11:26:39 AM
post Re: Peak Primary current in small DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Jesperb123
November 25, 2020, 10:45:43 AM
post Re: SSTC issues (gate signal, interrupter-mode, grounding)
[Solid State Tesla Coils (SSTC)]
davekni
November 25, 2020, 01:56:06 AM
post Re: SSTC issues (gate signal, interrupter-mode, grounding)
[Solid State Tesla Coils (SSTC)]
Max Seiringer
November 24, 2020, 11:12:02 PM
post Re: Peak Primary current in small DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Hydron
November 24, 2020, 10:44:00 PM
post Re: QCW with replaceable ferrite-core primary
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
November 24, 2020, 07:52:01 PM
post Re: QCW with replaceable ferrite-core primary
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Uspring
November 24, 2020, 05:32:56 PM
post Re: Peak Primary current in small DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Jesperb123
November 24, 2020, 05:09:57 PM
post Re: Peak Primary current in small DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Hydron
November 24, 2020, 04:57:21 PM
post Re: Peak Primary current in small DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Jesperb123
November 24, 2020, 03:37:11 PM
post Re: Safety relay (emergency stop) with galvanic isolation
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Netzpfuscher
November 24, 2020, 01:16:46 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal