Author Topic: Improving IGBT gate drive  (Read 112 times)

Offline Nijin

  • High Voltage Enthusiast
  • *
  • Posts: 17
  • Karma: +1/-0
    • View Profile
Improving IGBT gate drive
« on: May 17, 2020, 11:53:54 AM »
Hi guys !

I'm working on my drsstc and after many researches on how to drive an igbt, i want to share with you a new design of the IGBT gate drive circuit. This circuit can be use to drive efficiently one or more IGBT in parallel.

Motivation :
New technologies of IGBT are more suitable for paralleling operations. When you want to build small to medium power SSTC, you can choose between IGBT module or TO247. As TO247 are cheaper, it could be a better choice to use two or more TO247 in parallel than using an IGBT module, especially if you want to drive them at high frequency.


Since I design DRSSTC, the most efficient gate driver circuit I saw is the circuit with a diode to shunt the gate resistance. The aim of the diode is to reduce the gate resistance when discharging the gate to turn off quickly the IGBT. But the reduction of this resistance increase the voltage on the gate because the RLC circuit of the driver is under-damped.


To solve this problem, instead of using a diode, you can use a PNP transistor close to the gate to short it. The discharge current will no longer go through the GDT and the current path will have a smaller loop which means a smaller parasitic inductance. You can find more information on the TI application report "Fundamentals of MOSFET and IGBT Gate Driver Circuits".


The other improvement is the current balancing in parallel operation. When paralleling IGBT, some stray inductance is present at the emitter of the IGBT modules. The value of stray inductance for
the two IGBTs could differ. Because the IGBTs are connected in parallel, the common ground voltage will remain the same for both the IGBTs but the auxiliary emitter voltages will differ. This voltage difference between the auxiliary emitter terminals of the two IGBTs results in current flow from one terminal to the other. Depending on the direction of the circulating current the actual voltage at the IGBT gates will either increase or decrease resulting in unequal current sharing.
To overcome this problem, you can use a emitter resistor to help attenuating the circulating current or/and use a common-mode choke in the gate path.

This lead me to design this gate driver circuit.

It requires only 3 additional components to improve the driving. and if you just want to use it to drive one transistor, you can simply solder jumper instead of the common mode choke.


To finish the design of this driver, i still need to find a reference for the D1, Q2 and L1.

Tell me what do you think about this circuit and if you have any comments :)

If you are curious you can find more information on this paper :
- TI Designs "IGBT Gate Driver Reference Design for Parallel IGBTs With Short-Circuit Protection and External BJT Buffer" TIDUC70A
- TI Application Report "Fundamentals of MOSFET and IGBT Gate Driver Circuits" SLUA618A
Everything is a fuse if you pass enough current

High Voltage Forum

Improving IGBT gate drive
« on: May 17, 2020, 11:53:54 AM »

 


* Recent Topics and Posts

post 315-446MHz 27dbm (0.5w at 446MHz) RF amp
[Radio Frequency]
kilohercas
Today at 06:38:15 AM
post Re: Isn't there a better way to make a custom toroid?
[General Chat]
Twospoons
Today at 03:24:49 AM
post Re: SSTC Micro
[Solid State Tesla Coils (SSTC)]
Magneticitist
Today at 03:24:20 AM
post Re: MMC for a 32kvac load
[Capacitor Banks]
Rowdy
Today at 03:23:33 AM
post Re: MMC for a 32kvac load
[Capacitor Banks]
Weston
Today at 03:06:20 AM
post Re: Isn't there a better way to make a custom toroid?
[General Chat]
johnf
Today at 01:33:47 AM
post MMC for a 32kvac load
[Capacitor Banks]
Rowdy
Today at 01:02:34 AM
post Re: Isn't there a better way to make a custom toroid?
[General Chat]
Rowdy
May 24, 2020, 11:47:26 PM
post Re: GDT cable specs
[Transformer (Ferrite Core)]
costas_p
May 24, 2020, 11:09:44 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General Chat]
Rowdy
May 24, 2020, 10:39:45 PM
post Re: GDT cable specs
[Transformer (Ferrite Core)]
station240
May 24, 2020, 09:55:49 PM
post Re: Working Principle Of Neon Transformer Circuit
[Transformer (Ferrite Core)]
davekni
May 24, 2020, 09:55:48 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General Chat]
Mads Barnkob
May 24, 2020, 08:16:40 PM
post Re: GDT cable specs
[Transformer (Ferrite Core)]
thecyberman
May 24, 2020, 05:38:27 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General Chat]
Rowdy
May 24, 2020, 02:33:55 PM
post Re: Freewheeling diodes are burning (Now other problems)
[Solid State Tesla Coils (SSTC)]
hip424
May 24, 2020, 02:31:39 PM
post Re: Working Principle Of Neon Transformer Circuit
[Transformer (Ferrite Core)]
iraquois
May 24, 2020, 02:08:53 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
May 24, 2020, 12:12:36 PM
post Re: Working Principle Of Neon Transformer Circuit
[Transformer (Ferrite Core)]
ritaismyconscience
May 24, 2020, 07:56:21 AM
post Re: Freewheeling diodes are burning (Now other problems)
[Solid State Tesla Coils (SSTC)]
ritaismyconscience
May 24, 2020, 03:09:57 AM
post Re: Working Principle Of Neon Transformer Circuit
[Transformer (Ferrite Core)]
davekni
May 23, 2020, 10:24:55 PM
post Re: GDT cable specs
[Transformer (Ferrite Core)]
johnf
May 23, 2020, 09:30:29 PM
post GDT cable specs
[Transformer (Ferrite Core)]
costas_p
May 23, 2020, 09:06:39 PM
post Re: Working Principle Of Neon Transformer Circuit
[Transformer (Ferrite Core)]
Mads Barnkob
May 23, 2020, 08:22:59 PM
post Re: Freewheeling diodes are burning (Now other problems)
[Solid State Tesla Coils (SSTC)]
davekni
May 23, 2020, 07:47:49 PM
post Re: Building a bigger DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
May 23, 2020, 07:41:41 PM
post Working Principle Of Neon Transformer Circuit
[Transformer (Ferrite Core)]
iraquois
May 23, 2020, 02:09:26 PM
post 600 Watt GEL Battery Charger Teardown - Signet Systems HB600-24B
[Electronic Circuits]
Mads Barnkob
May 23, 2020, 12:46:23 PM
post Re: Building a bigger DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
May 23, 2020, 04:14:52 AM
post Re: New projet OmegaDR
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
May 22, 2020, 01:15:36 AM
post Re: New projet OmegaDR
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mugi30
May 21, 2020, 11:55:37 PM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
May 21, 2020, 07:46:28 PM
post Re: New projet OmegaDR
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mugi30
May 21, 2020, 09:15:57 AM
post Re: How to get rid of stuff?
[Sell / Buy / Trade]
johnf
May 21, 2020, 06:35:31 AM
post Re: How to get rid of stuff?
[Sell / Buy / Trade]
MRMILSTAR
May 21, 2020, 05:23:40 AM
post Re: Easy to build Polyphonic MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
futurist
May 21, 2020, 12:16:04 AM
post Re: How to get rid of stuff?
[Sell / Buy / Trade]
klugesmith
May 20, 2020, 11:22:34 PM
post Re: Powerful easy to build MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
May 20, 2020, 12:15:43 PM
post Re: Portable Q(uarantine)CW Tesla Coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
SteveN87
May 19, 2020, 02:08:20 PM
post Re: New projet OmegaDR
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mugi30
May 19, 2020, 12:05:51 PM
post Re: Powerful easy to build MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
May 19, 2020, 11:49:02 AM
post Re: Powerful easy to build MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
May 19, 2020, 09:26:06 AM
post Re: Portable Q(uarantine)CW Tesla Coil
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Weston
May 19, 2020, 07:55:54 AM
post Re: What's the best way to trigger these things?
[Capacitor Banks]
klugesmith
May 19, 2020, 01:55:11 AM
post Re: New projet OmegaDR
[Dual Resonant Solid State Tesla coils (DRSSTC)]
ritaismyconscience
May 18, 2020, 11:54:27 PM
post Re: New projet OmegaDR
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mugi30
May 18, 2020, 10:10:09 PM
post Re: New projet OmegaDR
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mugi30
May 18, 2020, 10:05:14 PM
post Re: What's the best way to trigger these things?
[Capacitor Banks]
johnf
May 18, 2020, 09:03:11 PM
post Re: What's the best way to trigger these things?
[Capacitor Banks]
John123
May 18, 2020, 07:50:08 PM
post Re: Powerful easy to build MIDI Interrupter
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Max
May 18, 2020, 04:15:16 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal