Author Topic: Question about secondary  (Read 125 times)

Offline thedoc298

  • High Voltage Enthusiast
  • *
  • Posts: 15
  • Karma: +0/-0
    • View Profile
Question about secondary
« on: April 18, 2019, 06:32:18 PM »
I have watched untold videos, but can't see what people are putting in the top of their secondary's. What goes in the hole at the top where the top load is to set.

Offline Fumeaux

  • High Voltage Experimenter
  • **
  • Posts: 59
  • Karma: +7/-0
    • View Profile
Re: Question about secondary
« Reply #1 on: April 18, 2019, 07:04:40 PM »
I'm not sure if you wanted to know about termination, but here is Mads design guide where he touches on secondary coil termination. If I remember it right most people epoxy acrylic disks into the pipe.

http://kaizerpowerelectronics.dk/tesla-coils/drsstc-design-guide/secondary-coil/

And I guess you are winding your secondary now?

Offline thedoc298

  • High Voltage Enthusiast
  • *
  • Posts: 15
  • Karma: +0/-0
    • View Profile
Re: Question about secondary
« Reply #2 on: April 18, 2019, 08:01:36 PM »
I'm not sure if you wanted to know about termination, but here is Mads design guide where he touches on secondary coil termination. If I remember it right most people epoxy acrylic disks into the pipe.

http://kaizerpowerelectronics.dk/tesla-coils/drsstc-design-guide/secondary-coil/

And I guess you are winding your secondary now?

Exactly what I needed, going to be hard to go wrong with all the good info here. Thanks a mil

Offline dexter

  • High Voltage Enthusiast
  • *
  • Posts: 20
  • Karma: +2/-0
    • View Profile
Re: Question about secondary
« Reply #3 on: April 18, 2019, 09:20:15 PM »
on all my SSTC's i used carbohydrate foam (also known as wood) for the end caps and never had an issue

Offline thedoc298

  • High Voltage Enthusiast
  • *
  • Posts: 15
  • Karma: +0/-0
    • View Profile
Re: Question about secondary
« Reply #4 on: April 18, 2019, 09:26:14 PM »
on all my SSTC's i used carbohydrate foam (also known as wood) for the end caps and never had an issue

Cool, thanks. Did not know if their was something special.

High Voltage Forum

Re: Question about secondary
« Reply #4 on: April 18, 2019, 09:26:14 PM »

 


* Recent Topics and Posts

post Re: DRSSTC design questions + project progress
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
Today at 08:31:55 PM
post Re: Easy access to optimal resonance frequency but the benefit is quite small
[Dual Resonant Solid State Tesla coils]
dexter
Today at 08:31:51 PM
post Easy access to optimal resonance frequency but the benefit is quite small
[Dual Resonant Solid State Tesla coils]
VNTC
May 21, 2019, 11:35:57 PM
post Re: Offgrid 48V solar to 24V battery setup
[Electronic circuits]
Mads Barnkob
May 21, 2019, 09:59:54 PM
post Re: General Oscilloscope Probing Techniques for (DR)SSTC h-bridge
[Beginners]
Mads Barnkob
May 21, 2019, 09:51:27 PM
post Re: ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
T3sl4co1l
May 21, 2019, 09:49:03 PM
post Re: ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
82026
May 21, 2019, 09:02:10 PM
post Re: DRSSTC design questions + project progress
[Dual Resonant Solid State Tesla coils]
Vaclav
May 21, 2019, 08:59:57 PM
post Re: DRSSTC design questions + project progress
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
May 21, 2019, 08:28:43 PM
post Re: Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
May 21, 2019, 08:22:28 PM
post Re: DRSSTC design questions + project progress
[Dual Resonant Solid State Tesla coils]
Vaclav
May 21, 2019, 06:21:37 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
May 21, 2019, 06:12:55 PM
post Re: DRSSTC design questions + project progress
[Dual Resonant Solid State Tesla coils]
profdc9
May 21, 2019, 04:06:38 PM
post Re: DRSSTC design questions + project progress
[Dual Resonant Solid State Tesla coils]
Vaclav
May 21, 2019, 03:56:56 PM
post Re: DRSSTC design questions + project progress
[Dual Resonant Solid State Tesla coils]
Vaclav
May 21, 2019, 03:46:56 PM
post Re: DRSSTC design questions + project progress
[Dual Resonant Solid State Tesla coils]
profdc9
May 21, 2019, 02:32:59 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
May 21, 2019, 06:12:18 AM
post Re: Offgrid 48V solar to 24V battery setup
[Electronic circuits]
profdc9
May 20, 2019, 11:30:34 PM
post DRSSTC design questions + project progress
[Dual Resonant Solid State Tesla coils]
Vaclav
May 20, 2019, 06:38:54 PM
post Re: General Oscilloscope Probing Techniques for (DR)SSTC h-bridge
[Beginners]
Teravolt
May 20, 2019, 06:33:49 PM
post Re: ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
82026
May 20, 2019, 02:27:59 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
May 20, 2019, 02:57:46 AM
post Re: ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
T3sl4co1l
May 20, 2019, 01:06:27 AM
post Re: ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
82026
May 19, 2019, 09:14:59 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
May 19, 2019, 06:40:41 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
flyrod
May 19, 2019, 04:04:12 PM
post Re: Offgrid 48V solar to 24V battery setup
[Electronic circuits]
Mads Barnkob
May 19, 2019, 11:24:46 AM
post Re: ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
flyrod
May 19, 2019, 03:22:54 AM
post Re: Are bleeder resistors necessary if I can easily discharge my capacitor?
[Spark gap Tesla coils]
profdc9
May 19, 2019, 03:18:52 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
May 18, 2019, 10:48:59 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Golddustpeak
May 18, 2019, 04:19:11 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
May 17, 2019, 10:57:17 PM
post Are bleeder resistors necessary if I can easily discharge my capacitor?
[Spark gap Tesla coils]
jpb133
May 17, 2019, 09:41:56 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Uspring
May 17, 2019, 12:41:17 PM
post ZVS Mazzilli circ with active gate driver - what causes ringing?
[Electronic circuits]
82026
May 16, 2019, 04:15:58 PM
post Re: Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Fumeaux
May 16, 2019, 02:19:39 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Golddustpeak
May 16, 2019, 01:50:44 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Uspring
May 16, 2019, 12:17:01 PM
post Re: Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Fumeaux
May 16, 2019, 08:45:15 AM
post Re: Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
May 15, 2019, 11:49:59 PM
post Re: Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Hydron
May 15, 2019, 10:51:33 PM
post Identification of unknown embedded computer, help needed.
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
May 15, 2019, 09:35:41 PM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Golddustpeak
May 15, 2019, 05:07:20 PM
post Re: Mounting LCD CFL's around DRSSTC?
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
May 15, 2019, 12:46:33 PM
post Re: General Oscilloscope Probing Techniques for (DR)SSTC h-bridge
[Beginners]
Mads Barnkob
May 15, 2019, 10:08:11 AM
post Re: Is one of these good?
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
May 15, 2019, 10:04:59 AM
post General Oscilloscope Probing Techniques for (DR)SSTC h-bridge
[Beginners]
L_Mangold
May 15, 2019, 12:42:46 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
May 14, 2019, 11:28:43 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
badpeter
May 14, 2019, 09:58:28 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
hightemp1
May 14, 2019, 08:35:28 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30