Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - coil1002

Pages: [1]
1
In the services of simplicity, I'd suggest trying something one of the following options:
- a single resistor in the region of 3-5 ohms (corresponding to the datasheet test spec resistance)
- a resistor as above, with an additional combination of another resistor for slowing turn-on (thus increasing effective dead-time) with a parallel diode for fast turn-off
If you're driving the gates with more than 15V then I'd lean towards 5+ ohms rather than 3.

In both cases scope the Vce and Vge waveforms - if there is Vge oscillation or excessive Vce turn-off spikes then increase the resistance. These IGBTs are pretty darn fast with low Qg, so I doubt that you're going to run into too-slow switching unless you use really large gate resistors.

I ended up  getting 5 ohm I will check the waveforms when its built. Thank you all for the responses they where incredibly helpful.

2
Which gate resistor calculator are you talking about? I wrote this to aid myself in playing with figures for DRSSTC: http://kaizerpowerelectronics.dk/calculators/igbt-gate-drive-calculator/

That would be the one Mads. I ended up using the current of the mosfet to calculate to. I came up with 3 ohms with the calculator so I bought 5 ohm resistors for tolerance

3
Dual Resonant Solid State Tesla coils / Gate Resistor Calculation
« on: May 12, 2019, 02:50:11 AM »
Hi all I am new to the forum. I have built quite a few Spark gap style coils throughout the years and am now trying my hand at my first DRSSTC. I am going to use loneoceans UD2.7 c for the driver and his 80mm Full bridge board for the bridge. I will be using FGA60N65SMD for the igbt's. I am having trouble wrapping my head around calculating the gate resistors values. Could someone point me in the right direction to a good place to read up on this ? I tried using the calculator but I am at a loss as to how to figure out the maximum gate drive current the driver is capable of. Better stated what do I calculated it off of? My assumption is the current of the mosfets that drive the bridge and if so is it x1 since there is a gate resistor per igbt or total current x4?

Any help would be greatly appreciated. Thank you

 

Pages: [1]

* Recent Topics and Posts

post making a useable induction forge.
[Transformer (iron core)]
rustedone
Today at 04:20:15 PM
post Re: 220ac to 440dc 5a boost convertor
[Voltage Multipliers]
rustedone
Today at 04:03:58 PM
post Analog Panel Meter Shunt Calculation and Custom Scale Design
[Beginners]
Mads Barnkob
Today at 07:56:20 AM
post Re: Mysterious Chinese HV capacitors
[Capacitor banks]
MRMILSTAR
Today at 05:40:55 AM
post Re: Mysterious Chinese HV capacitors
[Capacitor banks]
davekni
Today at 03:33:52 AM
post WTS [US]: pole transformer, SRSG, PTs, NSTs, capacitors, variacs, [MORE]
[Sell / Buy / Trade]
acobaugh
October 15, 2019, 09:36:55 PM
post Mysterious Chinese HV capacitors
[Capacitor banks]
MRMILSTAR
October 15, 2019, 09:12:09 PM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
October 15, 2019, 12:38:24 PM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
davekni
October 14, 2019, 10:02:07 PM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
Weston
October 14, 2019, 08:46:54 PM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
MRMILSTAR
October 14, 2019, 08:28:19 PM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
davekni
October 14, 2019, 07:27:22 PM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
davekni
October 14, 2019, 07:01:34 PM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
MRMILSTAR
October 14, 2019, 04:23:56 PM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
klugesmith
October 14, 2019, 07:27:49 AM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
T3sl4co1l
October 14, 2019, 07:10:39 AM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
MRMILSTAR
October 14, 2019, 05:43:57 AM
post Re: so far video
[Spark gap Tesla coils]
davekni
October 14, 2019, 05:40:27 AM
post Re: Drsstc 4 (new direction)
[Dual Resonant Solid State Tesla coils]
davekni
October 14, 2019, 05:23:48 AM
post Re: Drsstc 4 (new direction)
[Dual Resonant Solid State Tesla coils]
oneKone
October 14, 2019, 04:37:49 AM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
davekni
October 14, 2019, 03:47:03 AM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
klugesmith
October 13, 2019, 11:05:25 PM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
davekni
October 13, 2019, 09:29:25 PM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
MRMILSTAR
October 13, 2019, 04:43:47 PM
post Re: My first DRSSTC on bricks
[Dual Resonant Solid State Tesla coils]
davekni
October 13, 2019, 07:04:20 AM
post Re: How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
davekni
October 13, 2019, 07:00:57 AM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
davekni
October 13, 2019, 06:36:13 AM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
Weston
October 13, 2019, 12:41:07 AM
post Re: My first DRSSTC on bricks
[Dual Resonant Solid State Tesla coils]
Hydron
October 13, 2019, 12:17:39 AM
post Re: My first DRSSTC on bricks
[Dual Resonant Solid State Tesla coils]
Laci
October 12, 2019, 11:21:39 PM
post How to measure voltage output of AC flyback transformer
[Transformer (ferrite core)]
MRMILSTAR
October 12, 2019, 08:37:36 PM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
davekni
October 12, 2019, 06:57:55 PM
post Re: so far video
[Spark gap Tesla coils]
thedoc298
October 12, 2019, 05:28:01 PM
post Re: 220ac to 440dc 5a boost convertor
[Voltage Multipliers]
rustedone
October 12, 2019, 04:58:28 PM
post Re: My first DRSSTC on bricks
[Dual Resonant Solid State Tesla coils]
Netzpfuscher
October 12, 2019, 03:53:12 PM
post Re: My first DRSSTC on bricks
[Dual Resonant Solid State Tesla coils]
Laci
October 12, 2019, 02:12:59 PM
post Re: 220ac to 440dc 5a boost convertor
[Voltage Multipliers]
rustedone
October 12, 2019, 10:43:48 AM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
ScottE
October 12, 2019, 07:38:47 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
davekni
October 12, 2019, 06:16:12 AM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
davekni
October 12, 2019, 05:52:51 AM
post Re: so far video
[Spark gap Tesla coils]
MRMILSTAR
October 12, 2019, 05:13:28 AM
post Re: Problems with my first DRSSTC
[Dual Resonant Solid State Tesla coils]
davekni
October 12, 2019, 04:41:19 AM
post Re: so far video
[Spark gap Tesla coils]
thedoc298
October 12, 2019, 02:58:19 AM
post Re: so far video
[Spark gap Tesla coils]
thedoc298
October 12, 2019, 02:56:17 AM
post Re: so far video
[Spark gap Tesla coils]
MRMILSTAR
October 12, 2019, 02:38:43 AM
post so far video
[Spark gap Tesla coils]
thedoc298
October 12, 2019, 12:26:44 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
T3sl4co1l
October 11, 2019, 11:33:19 PM
post Re: My first DRSSTC on bricks
[Dual Resonant Solid State Tesla coils]
Netzpfuscher
October 11, 2019, 11:17:17 PM
post Re: DRSSTC with litz-wire primary and 40 x TO247 IGBT H-Bridge
[Dual Resonant Solid State Tesla coils]
Hydron
October 11, 2019, 10:06:32 PM
post Re: My first DRSSTC on bricks
[Dual Resonant Solid State Tesla coils]
Laci
October 11, 2019, 09:03:38 PM