Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tefatronix

Pages: [1]
1
Solid state Tesla coils / Re: Self-oscillating nano Tesla Coil (14.3 MHz)
« on: January 10, 2018, 09:11:50 PM »
This looks really nice. However...
14.3 Mhz is right in the middle of the 20M amateur radio
band, and you are likely to be causing havoc for up to
hundreds of miles. The 20M is the best long distance
radio band and I can communicate round the world with
just a few watts of power. A Tesla coil operating on this
frequency is really bad news. Sorry.

Mike


 I will try to read more on that subject, meanwhile I do not think the actual radiated power is very high and I operate the Tesla coil very rarely, I can try to decrease the operating frequency by a few hundred kHz to (or as close as possible to) the 13.56 MHz ISM band, together with an added tuning capacitor, this could improve performance of the coil as well.

2
Solid state Tesla coils / Re: Self-oscillating nano Tesla Coil (14.3 MHz)
« on: November 02, 2017, 09:53:32 PM »
That is a wonderful little coil!

How long can you run it at 12VDC input with that heat sink staying below burning-my-fingers temperature?

Would tuning capacitor get more critical with lower resonant frequency?, as I imagine the low internal capacitance would then no longer be enough.

Did you try to replace the metal screws/nuts and spacers to a plastic material to see if it improved efficiency, not that I think it is a problem at these extremely small power levels, but it is still very close to the primary/secondary circuit.


Thanks!

I have usually only used it for a few minutes at 12-14 VDC and maybe 30 s - 1 min at higher voltages, the heating isn't that extreme at 12 V and I think it could run at that voltage without being at finger-burning temperatures for much longer than that, but it creates a lot of EMI (the effect of EMI is MUCH more noticeable at this frequency than at (for example) 1 MHz) and it makes only a small discharge at these voltages...

Haven't tested plastic screws or decreasing the operating frequency, I plan to do so sometime later (however I have lots of other stuff to do + this coil needs an interrupter so I can increase the input voltage to 24 V for longer periods of time, I plan to build a battery+boost+interrupter pack), but with the previous BJT-based version it played a visible role, decreasing or increasing it too far would result in much higher heating and/or lower spark output (if you are interested in the schematic of the old version, it's documented here, although it is not very impressive - essentially a modified BJT based Slayer exciter with the same output stage as what's in this TC). Adding a small capacitance here results in no spark length increase or even some decrease.

3
Solid state Tesla coils / Self-oscillating nano Tesla Coil (14.3 MHz)
« on: October 31, 2017, 09:27:37 PM »
Hi all, I'm a student from the Czech Republic and this is my first post on this forum, in which I am going to show you my miniature Tesla coil.

I have already posted this in a few Facebook groups before, but in case anybody is interested, here it is.
This is my smallest Tesla coil, the circuit board measures 25x20 mm, the secondary coil has the following parameters: 14.3 MHz fres, 10 mm diameter, 25 mm winding height, 0.1 mm wire diameter.

It is very similar to Slayer exciters and to a self-oscillating coil another member posted here some time ago. The input stage uses extra 1N4148 diodes to decrease the capacitance of the Zener diodes and uses a simple circuit (zener, trimpot, some resistors) to slightly bias the MOSFET gate. The output stage wired in a class E like configuration, however I don't use any capacitor in parallel to the MOSFET's output, as it seems to be in tune even without it. I haven't measured the waveforms, as my scope is quite slow and its input capacitance is not negligible. The MOSFET I use here is an IRF510 - this one was chosen because of its low gate capacitance, low price, easy availability and fairly high speed (I think it would be quite challenging to get an IRFP460 to run at such frequencies  ;D )

I built this coil to have an "improved version" to replace my previous nano Tesla coil, which got damaged and was very inefficient anyway (based on a BD139 NPN BJT in a very similar circuit to this one - it had a different bias circuit and a 150 pF tuning capacitor). I've already had this coil laying here for a few weeks or even months, but I was too lazy to write any documentation, but finally got myself to do it (full documentation is here).

This coil can run off a 12-14 volt power supply without overheating, it can momentarily tolerate higher voltages (I tested it at voltages over 24 V) as long as the input is pulsed, otherwise it will overheat fairly quickly. At voltages under approximately 15 V or so, the discharge has to be started manually with a piece of metal, etc.

Pages: [1]

* Recent Topics and Posts

post Re: CM300 coil build questions
[Dual Resonant Solid State Tesla coils]
acobaugh
September 18, 2019, 07:27:46 PM
post Re: CM300 coil build questions
[Dual Resonant Solid State Tesla coils]
acobaugh
September 18, 2019, 06:56:20 PM
post Re: CM300 coil build questions
[Dual Resonant Solid State Tesla coils]
acobaugh
September 18, 2019, 05:08:06 PM
post Re: CM300 coil build questions
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
September 18, 2019, 01:35:58 PM
post Re: CM300 coil build questions
[Dual Resonant Solid State Tesla coils]
acobaugh
September 18, 2019, 05:54:23 AM
post Re: Blast from the past!
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
klugesmith
September 18, 2019, 05:05:55 AM
post Re: UD2.7 Gate Signals
[Dual Resonant Solid State Tesla coils]
coilinator
September 17, 2019, 08:24:59 PM
post Re: Blast from the past!
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
MRMILSTAR
September 17, 2019, 08:19:45 PM
post Re: Blast from the past!
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
Mads Barnkob
September 17, 2019, 06:53:52 PM
post Blast from the past!
[Computers, Microcontrollers, Programmable Logic, Interfaces and Displays]
MRMILSTAR
September 17, 2019, 05:52:00 PM
post Re: CM300 coil build questions
[Dual Resonant Solid State Tesla coils]
acobaugh
September 17, 2019, 05:00:47 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
davekni
September 17, 2019, 06:48:38 AM
post Re: My second DRSSTC
[Dual Resonant Solid State Tesla coils]
erdal
September 16, 2019, 11:07:27 PM
post Re: 750W solar offgrid 24V/150Ah battery setup with Victron charger
[Electronic circuits]
johnf
September 16, 2019, 09:48:37 PM
post Re: adventures in homemade flyback bobbins.
[Transformer (ferrite core)]
AlexanderHun
September 16, 2019, 10:42:44 AM
post Re: Offgrid 48V solar to 24V battery setup
[Electronic circuits]
Mads Barnkob
September 16, 2019, 09:40:27 AM
post Re: My second DRSSTC
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
September 16, 2019, 09:28:43 AM
post Re: Large Ferrite Core with IGBT-Brick Driver
[Transformer (ferrite core)]
Mads Barnkob
September 16, 2019, 09:24:17 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
T3sl4co1l
September 16, 2019, 06:59:12 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
davekni
September 16, 2019, 04:18:26 AM
post Re: My second DRSSTC
[Dual Resonant Solid State Tesla coils]
davekni
September 16, 2019, 02:49:28 AM
post Re: Large Ferrite Core with IGBT-Brick Driver
[Transformer (ferrite core)]
davekni
September 16, 2019, 02:43:18 AM
post Re: Homemade HV transformer
[Transformer (ferrite core)]
davekni
September 16, 2019, 02:36:17 AM
post Re: adventures in homemade flyback bobbins.
[Transformer (ferrite core)]
davekni
September 16, 2019, 02:26:40 AM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic circuits]
petespaco
September 16, 2019, 01:50:19 AM
post Re: UD2.7 Gate Signals
[Dual Resonant Solid State Tesla coils]
coilinator
September 15, 2019, 08:22:47 PM
post Re: My second DRSSTC
[Dual Resonant Solid State Tesla coils]
erdal
September 15, 2019, 02:09:17 PM
post Re: Homemade HV transformer
[Transformer (ferrite core)]
AlexanderHun
September 15, 2019, 10:39:29 AM
post Re: Homemade HV transformer
[Transformer (ferrite core)]
ElectroXa
September 14, 2019, 07:01:28 PM
post Re: adventures in homemade flyback bobbins.
[Transformer (ferrite core)]
AlexanderHun
September 14, 2019, 06:59:13 PM
post Re: Homemade HV transformer
[Transformer (ferrite core)]
AlexanderHun
September 14, 2019, 06:43:15 PM
post Re: Homemade HV transformer
[Transformer (ferrite core)]
ritaismyconscience
September 14, 2019, 06:35:32 PM
post Homemade HV transformer
[Transformer (ferrite core)]
AlexanderHun
September 14, 2019, 05:05:00 PM
post Re: UD2.7 Gate Signals
[Dual Resonant Solid State Tesla coils]
profdc9
September 14, 2019, 04:50:10 PM
post Re: UD2.7 Gate Signals
[Dual Resonant Solid State Tesla coils]
coilinator
September 14, 2019, 08:42:55 AM
post Re: Transistors good for DRSSTC?
[Dual Resonant Solid State Tesla coils]
ritaismyconscience
September 13, 2019, 05:50:53 AM
post Re: Transistors good for DRSSTC?
[Dual Resonant Solid State Tesla coils]
Max
September 12, 2019, 12:47:03 PM
post Re: Transistors good for DRSSTC?
[Dual Resonant Solid State Tesla coils]
Mads Barnkob
September 12, 2019, 11:07:39 AM
post Re: "karma", "applause/smite" button meaning and use
[General chatting]
Mads Barnkob
September 12, 2019, 11:01:05 AM
post Re: Transistors good for DRSSTC?
[Dual Resonant Solid State Tesla coils]
Hydron
September 12, 2019, 08:44:48 AM
post Transistors good for DRSSTC?
[Dual Resonant Solid State Tesla coils]
ritaismyconscience
September 12, 2019, 05:53:51 AM
post Re: "karma", "applause/smite" button meaning and use
[General chatting]
oneKone
September 12, 2019, 05:37:11 AM
post "karma", "applause/smite" button meaning and use
[General chatting]
MRMILSTAR
September 12, 2019, 05:07:24 AM
post Re: Why did 4HV die??
[General chatting]
oneKone
September 12, 2019, 04:50:24 AM
post Drsstc 4, I'm never stopping
[Dual Resonant Solid State Tesla coils]
oneKone
September 12, 2019, 02:36:00 AM
post Re: Why did 4HV die??
[General chatting]
Hydron
September 12, 2019, 12:34:10 AM
post Re: Why did 4HV die??
[General chatting]
MRMILSTAR
September 11, 2019, 09:29:40 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
MRMILSTAR
September 11, 2019, 09:00:31 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
coilinator
September 11, 2019, 07:54:30 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General chatting]
freq_out
September 11, 2019, 05:40:14 PM