Author Topic: Global shutter synchronized to arcs?  (Read 3792 times)

Online davekni

  • Executive Board Member
  • *******
  • Posts: 3001
  • Karma: +142/-2
  • Physicist, engineer (electronic), and hobbiest
    • View Profile
Global shutter synchronized to arcs?
« on: July 19, 2021, 06:32:35 AM »
Just a thought at this point.  Does anyone have a global-shutter camera?  It would be interesting to sync the camera exposure with DRSSTC sparks.  With a properly timed and short exposure it should be possible to get good arc images in brighter background situations.  Synchronized global-shutter video could allow daytime DRSSTC testing while still monitoring for errant sparks.

Two possibilities for synchronizing.  The likely-easier option would be to use a camera output intended for strobe-light triggering to trigger single DRSSTC enable pulses.  The down-side of this option is longer exposure times (unless the camera has an option to generate a trigger slightly prior to shutter opening.)

The other possibility is to trigger camera exposure from the DRSSTC enable pulse, perhaps with some controlled added delay.  Then the exposure could be short, covering just the active arc portion of the DRSSTC pulse.

I've built similar systems at work for strobed microscope viewing of ink drops.  Unfortunately, I don't think there's any equipment available to borrow.  I see cheap (~$70) global-shutter webcams from China.  Can't find any information about options for trigger input or strobe output.  The cheapest global-shutter camera I've found that lists trigger capability is $200+shipping.  Perhaps someday when my project list gets short ;) I'll buy a camera and experiment.  That is if no one else has tried it first.
David Knierim

Offline klugesmith

  • High Voltage Senior
  • *****
  • Posts: 799
  • Karma: +25/-0
    • View Profile
Re: Global shutter synchronized to arcs?
« Reply #1 on: July 19, 2021, 06:49:08 PM »
Nice idea there.
I bet a typical visible arc is the sum of many DRSSTC pulses following the same ionized air channel, as with natural lightning.   Maybe the first pulse is not the brightest.

Do global shutter digital cameras allow independent control of the shutter duration?

Using camera shutter as the master, to trigger the DRSSTC as it might trigger an electronic flash,
would work even with a film camera.  Many film cameras have global shutter times down to 1/500 second, with flash trigger at beginning of the wide-open time.

Offline TMaxElectronics

  • High Voltage Engineer
  • ****
  • Posts: 299
  • Karma: +24/-0
    • View Profile
    • My random (and very empty) electronics blog
Re: Global shutter synchronized to arcs?
« Reply #2 on: July 20, 2021, 12:09:36 AM »
I guess the easiest way would be to trigger them the way flashes are triggered. Not quite sure why that should result in longer exposure times though. You can still adjust all parameters in full manual mode. And the few 100 microseconds probably don't make too much difference either I'd guess.

The camera flash approach could actually be really easy, just a monostable 555, a photodiode and an IR filter from a remote control or something like that. I remember some of the old photo-flashes detecting the main flash like that, without requiring a special emitter on the camera. I'm assuming they just look for the IR pulse from the flash tube of the camera.

Online davekni

  • Executive Board Member
  • *******
  • Posts: 3001
  • Karma: +142/-2
  • Physicist, engineer (electronic), and hobbiest
    • View Profile
Re: Global shutter synchronized to arcs?
« Reply #3 on: July 20, 2021, 04:43:05 AM »
Quote
I bet a typical visible arc is the sum of many DRSSTC pulses following the same ionized air channel, as with natural lightning.   Maybe the first pulse is not the brightest.
Yes, I'm confident you are right.  With high detuning, the first few pulses make very short weak arcs.  That shows up in scope measurements and sequential video frames.  Also, each pulse's arc generally displaces slightly from the previous path due to air motion - showing up as beautiful parallel paths in images.  Having the DRSSTC electronics trigger camera exposure would allow triggering on the Nth pulse where the arc is strong (presuming smart electronics).

Quote
Do global shutter digital cameras allow independent control of the shutter duration?
Not certain I know what "independent" means here.  The cameras we use at work have options for either programmed exposure time started by an edge of an external signal or for exposure to match the width of the external pulse.

The ideal (in my mind) camera would allow multiple short exposures with independent control of exposure (shutter open and close) and when the exposure-generated charge is transferred to readout circuitry (CCD cells or CMOS capacitors).  That would allow multi-arc images.  Would be useful at work too.  However, the global-shutter cameras I've seen always transfer charge at the end of the exposure window, with no separate control.

Quote
Not quite sure why that should result in longer exposure times though. You can still adjust all parameters in full manual mode. And the few 100 microseconds probably don't make too much difference either I'd guess.
Exposure times are longer because exposure starts (slightly) before DRSSTC pulse starts.  The arc doesn't start until primary current has built up and a significant fraction of primary energy transferred to secondary.  Starting exposure as or after the arc forms allows shorter exposure.  Daytime is very bright.  It will require short exposures to not swamp arc light with daylight.  Longer (but still short) exposures would be useful closer to dusk when daylight is lower.

Quote
The camera flash approach could actually be really easy, just a monostable 555, a photodiode and an IR filter from a remote control or something like that. I remember some of the old photo-flashes detecting the main flash like that, without requiring a special emitter on the camera. I'm assuming they just look for the IR pulse from the flash tube of the camera.
Yes, I agree, the camera flash approach is easier.  Just more limited.
David Knierim

Offline Uspring

  • High Voltage Engineer
  • ****
  • Posts: 348
  • Karma: +32/-1
  • Physicist
    • View Profile
Re: Global shutter synchronized to arcs?
« Reply #4 on: July 21, 2021, 05:10:18 PM »
Quote
With high detuning, the first few pulses make very short weak arcs.
IIRC, the first 2 or 3 bursts of a longer sequence in Hydrons measurement https://highvoltageforum.net/index.php?topic=117.msg735#msg735 showed a considerably higher arc voltage and a bit lower arc current compared to the later ones. Higher voltages and lower currents likely imply a lower capacitance, so probably shorter arcs and possibly less bright ones. A dependency on the tuning conditions seems quite plausible.
Quote
The ideal (in my mind) camera would allow multiple short exposures with independent control of exposure (shutter open and close) and when the exposure-generated charge is transferred to readout circuitry (CCD cells or CMOS capacitors).
The CCDs I used to work with (long time ago) only had a single charge path from the photo sites. This went to the analog shift register. For a multiply shuttered exposure, you'd need to dump photo electrons somewhere else for the unwanted exposure time. The CCDs I remember did not have a path for this.

High Voltage Forum

Re: Global shutter synchronized to arcs?
« Reply #4 on: July 21, 2021, 05:10:18 PM »

 


* Recent Topics and Posts

post Re: im new to tesla coils and i think i screwed up
[Spark Gap Tesla Coils (SGTC)]
davekni
Today at 09:09:38 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
haversin
Today at 08:45:14 PM
post im new to tesla coils and i think i screwed up
[Spark Gap Tesla Coils (SGTC)]
noahbmaker
Today at 08:04:14 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
alan sailer
Today at 07:47:52 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
Uspring
Today at 07:34:38 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
haversin
Today at 05:48:16 PM
post Re: Big Coil Build Log
[Dual Resonant Solid State Tesla coils (DRSSTC)]
flyingperson23
Today at 03:20:08 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
Uspring
Today at 01:50:30 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General Chat]
shBLOCK
Today at 07:39:21 AM
post Re: First DRSSTC, Full Bridge PCB & IGBT Selection question.
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Benjamin Lockhart
Today at 04:14:03 AM
post Re: First DRSSTC, Full Bridge PCB & IGBT Selection question.
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
Today at 01:12:38 AM
post Re: Testing and teardown of a commercial induction heater
[Electronic Circuits]
dejuli2
December 11, 2024, 09:58:07 PM
post Re: Push Pull VTTC
[Vacuum Tube Tesla Coils (VTTC)]
myoniwy
December 11, 2024, 09:26:40 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General Chat]
myoniwy
December 11, 2024, 09:08:24 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
haversin
December 11, 2024, 08:05:20 PM
post Re: First DRSSTC, Full Bridge PCB & IGBT Selection question.
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Beggernator.
December 11, 2024, 03:48:40 PM
post Re: APC Back-UPS Pro 1500 Watt Teardown
[Electronic Circuits]
Mr.Cas
December 11, 2024, 05:27:48 AM
post Re: First DRSSTC, Full Bridge PCB & IGBT Selection question.
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
December 11, 2024, 01:41:52 AM
post Re: First DRSSTC, Full Bridge PCB & IGBT Selection question.
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Beggernator.
December 10, 2024, 04:18:23 PM
post Re: Ferrite transformer from Microwave
[Transformer (Ferrite Core)]
davekni
December 10, 2024, 04:05:07 AM
post Attracting (and picking up) nonferrous metals with an electromagnet
[Electronic Circuits]
davekni
December 10, 2024, 02:49:03 AM
post Ferrite transformer from Microwave
[Transformer (Ferrite Core)]
Simranjit
December 09, 2024, 11:37:35 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
alan sailer
December 07, 2024, 09:41:37 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
haversin
December 07, 2024, 07:07:49 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
alan sailer
December 07, 2024, 06:33:32 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
haversin
December 07, 2024, 06:13:56 PM
post Re: Measuring the coherence length of a laser
[Light, Lasers and Optics]
alan sailer
December 07, 2024, 02:40:55 AM
post Measuring the coherence length of a laser
[Light, Lasers and Optics]
haversin
December 07, 2024, 01:07:46 AM
post Re: Single board for SSTC and DRSSTC operation
[Solid State Tesla Coils (SSTC)]
davekni
December 07, 2024, 12:18:49 AM
post Re: Single board for SSTC and DRSSTC operation
[Solid State Tesla Coils (SSTC)]
Simranjit
December 06, 2024, 11:59:05 PM
post Re: First DRSSTC, Full Bridge PCB & IGBT Selection question.
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
December 06, 2024, 11:33:05 PM
post Re: Single board for SSTC and DRSSTC operation
[Solid State Tesla Coils (SSTC)]
davekni
December 06, 2024, 11:28:25 PM
post Re: Welcome new members, come say hello and tell a little about yourself :)
[General Chat]
GaelJaton
December 06, 2024, 09:47:04 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal