Conical pulse skip DRSSTC

[Acid Byte]

Almost completed building my conical coil.
Learned allot in the last year hehehe.



Overview of the coil assembly





Skm200 H-bridge



TEDR (modded ud2.5)



Fan control and lockout + softstart




Tank cap



Power distribution + control lights


Saving money for a lathe toroid atm.
Would be a nice addition to the looks =)

Ill post some of the specs and videos later.

[Mads Barnkob]

A very rare conical coil, I heard they were such a pain to wind that I never tried it How was your experience with slipping wire and did you start from the top to let it slip up against that turn?

Looking forward to see the specs, I was just wondering if 2x 2200uF is enough bus capacitance for pulse skipping without serious dc bus sagging?

You also printed a lot of parts for this coil, my favorites are by far the "square-aluminum-bar-to-wood" adapter for fastening the primary platform with! Did you share your models on some 3D printer websites?

[Acid Byte]

A very rare conical coil, I heard they were such a pain to wind that I never tried it How was your experience with slipping wire and did you start from the top to let it slip up against that turn?

Actually dont try it unless you have to much time...
I actually had to build it a couple of times to get it right.

First had lots of internal form arcing...
Before i filled the form up with expanding foam and polyester.

Yeah it was wound from top to bottom. Kinda the only way hehehehe

Looking forward to see the specs, I was just wondering if 2x 2200uF is enough bus capacitance for pulse skipping without serious dc bus sagging?

Yeah those caps might come a bit short.
I have some caps with double the capacitance laying arround.
Might be thinking of replacing them.
Coil is working fine so far though

/>

You also printed a lot of parts for this coil, my favorites are by far the "square-aluminum-bar-to-wood" adapter for fastening the primary platform with! Did you share your models on some 3D printer websites?

Havmt shared any of the files yet.
I might when its finished!