Author Topic: New here First Post Cap question 2x10nf 37.5kv  (Read 2686 times)

Offline HVfun

  • High Voltage Enthusiast
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
New here First Post Cap question 2x10nf 37.5kv
« on: April 10, 2018, 04:38:53 PM »
I have a couple large box caps that are about 65mm x110mmx200mm They have (EFD Sp2512 2x10nF +/-10% 37.5KV 00/3 670) stamped on them. They have 3 wires coming out of them. If I measure the two outside wires it measures 5nf. If I go one outside and to center wire it reads 10nf.  I assume that I can only use either one at 10nf or together at 5nf.But not two single 10nf caps. Is this correct. Also the 35KV would that be for each side or in series? They came out of a 150kv X ray tank. These were in oil. I assume I would need to put them back in oil to be able to use them. Am I thinking correctly?


I would like to use them in a small TC. More on that later.

thanks in advance


Offline Mads Barnkob

  • Administrator
  • High Voltage Expert
  • *****
  • Posts: 1783
  • Karma: +46/-0
  • Denmark
    • View Profile
    • Kaizer Power Electronics
Re: New here First Post Cap question 2x10nf 37.5kv
« Reply #1 on: April 10, 2018, 09:58:04 PM »
Hi HVfun and welcome to HVF!

I would assume that they are in series and the way the connections are arranged is to make it easier to construct a voltage doubler simply by adding diodes to the brass mounting holes / wires.

Unfortunately the EFD model numbers does not make much sense, there is a famous SP2550-2 capacitor (3.75uF 680Arms snubber capacitor), but that is way different from this.

Does it feel empty/hollow? I can follow your worries about them needing to be under oil when they got holes into it from where the wires come out.
https://kaizerpowerelectronics.dk - Tesla coils, high voltage, pulse power, audio and general electronics
https://www.youtube.com/KaizerPowerElectronicsDk60/join - Please consider supporting the forum, websites and youtube channel!

Offline HVfun

  • High Voltage Enthusiast
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: New here First Post Cap question 2x10nf 37.5kv
« Reply #2 on: April 11, 2018, 05:13:23 AM »
Yes it looks like this was part of a full wave voltage multiplier circuit. There was some diode boards that contained 11 c37-10 diodes in series per side. There were two of the diode boards and two small transformers that had large flat wire primary's and 30 awg secondaries. I think the secondaries were connected to the diodes and then to the caps in a multiplier circuit. The tank these came out of had a sticker 256v primary 1 phase 15khz.

See attached pics of diodes and small transformers.

I wonder what the output of the little transformer would be. I looks like it was ran through a Eupec 96amp SCR Doubler w/aux Cathode. I need to make a little tank to hold the transformer in oil I think to try it. Do you think it will work on 60hz mains thru a variac or only work at 15khz?

The large box caps seem hollow. Not potted. I can move the center wire around a bit and it moves a board or plate inside. I can jiggle the box and hear a thud as a plate or something is moving a little inside.

How do I tell what side is positive and what side is negative or does it matter for these caps?




High Voltage Forum

Re: New here First Post Cap question 2x10nf 37.5kv
« Reply #2 on: April 11, 2018, 05:13:23 AM »

 


* Recent Topics and Posts

post Re: Tesla Coil Show Controller Project
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Max
Today at 11:13:18 AM
post Re: repair of Panasonic microwave inverter
[Electronic Circuits]
Weston
Today at 10:08:34 AM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
Today at 03:20:42 AM
post Re: repair of Panasonic microwave inverter
[Electronic Circuits]
Twospoons
Today at 03:16:27 AM
post 3kW Cisco Server Supply teardown and help needed
[Electronic Circuits]
Da_Stier
July 23, 2021, 09:23:11 PM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
thedoc298
July 23, 2021, 08:05:58 PM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
futurist
July 23, 2021, 07:02:18 PM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
thedoc298
July 23, 2021, 05:33:57 PM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GKnapp
July 23, 2021, 04:51:37 PM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 23, 2021, 03:52:46 AM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
thedoc298
July 22, 2021, 10:59:32 PM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GKnapp
July 22, 2021, 08:50:34 PM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
July 22, 2021, 08:47:23 PM
post Help needed - which IGBT module to buy
[Dual Resonant Solid State Tesla coils (DRSSTC)]
thedoc298
July 22, 2021, 07:01:24 PM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 22, 2021, 06:50:07 AM
post Re: Proper phase lead adjustment at the input
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 22, 2021, 06:39:37 AM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
alan sailer
July 21, 2021, 07:55:03 PM
post Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GKnapp
July 21, 2021, 06:34:13 PM
post Re: Global shutter synchronized to arcs?
[DSLR]
Uspring
July 21, 2021, 05:10:18 PM
post Re: Tesla Coil Show Controller Project
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
July 21, 2021, 12:42:29 PM
post Re: Proper phase lead adjustment at the input
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Chrisader
July 21, 2021, 08:15:00 AM
post Re: Proper phase lead adjustment at the input
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 21, 2021, 04:57:04 AM
post Re: Micro-power continuity checker.
[Electronic Circuits]
davekni
July 21, 2021, 03:50:33 AM
post Re: Skm flyback destroyer 🤗
[Transformer (Ferrite Core)]
oneKone
July 21, 2021, 01:50:19 AM
post Proper phase lead adjustment at the input
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Chrisader
July 20, 2021, 10:06:14 PM
post Re: Micro-power continuity checker.
[Electronic Circuits]
klugesmith
July 20, 2021, 06:24:29 PM
post Micro-power continuity checker.
[Electronic Circuits]
davekni
July 20, 2021, 05:37:36 AM
post Re: Help needed with SSTC. First TC build
[Solid State Tesla Coils (SSTC)]
davekni
July 20, 2021, 05:08:24 AM
post Re: Global shutter synchronized to arcs?
[DSLR]
davekni
July 20, 2021, 04:43:05 AM
post Re: Global shutter synchronized to arcs?
[DSLR]
TMaxElectronics
July 20, 2021, 12:09:36 AM
post Re: Help needed with SSTC. First TC build
[Solid State Tesla Coils (SSTC)]
AstRii
July 19, 2021, 11:13:13 PM
post Another question on CT Feedback
[Solid State Tesla Coils (SSTC)]
Maverikie
July 19, 2021, 08:56:04 PM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
newage
July 19, 2021, 07:09:56 PM
post Re: Global shutter synchronized to arcs?
[DSLR]
klugesmith
July 19, 2021, 06:49:08 PM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
klugesmith
July 19, 2021, 04:39:05 PM
post Global shutter synchronized to arcs?
[DSLR]
davekni
July 19, 2021, 06:32:35 AM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
MRMILSTAR
July 19, 2021, 05:22:51 AM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
newage
July 19, 2021, 04:24:38 AM
post Re: a typical sstc half bridge design, any considerations or tips?
[Solid State Tesla Coils (SSTC)]
eli
July 19, 2021, 12:35:18 AM
post Re: a typical sstc half bridge design, any considerations or tips?
[Solid State Tesla Coils (SSTC)]
Mads Barnkob
July 19, 2021, 12:15:43 AM
post a typical sstc half bridge design, any considerations or tips?
[Solid State Tesla Coils (SSTC)]
eli
July 18, 2021, 11:44:03 PM
post Re: HFSSTC design help and questions
[Solid State Tesla Coils (SSTC)]
eli
July 18, 2021, 09:33:40 PM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
johnf
July 18, 2021, 09:07:15 PM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
MRMILSTAR
July 18, 2021, 03:38:01 PM
post Best and stable version of video
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Transgarp
July 18, 2021, 03:33:31 PM
post Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
newage
July 18, 2021, 01:30:46 PM
post Re: DRSSTC design advise / Primary peak current calculation
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
July 17, 2021, 10:05:39 AM
post Re: DRSSTC design advise / Primary peak current calculation
[Dual Resonant Solid State Tesla coils (DRSSTC)]
alan sailer
July 16, 2021, 11:01:43 PM
post Re: DRSSTC design advise / Primary peak current calculation
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Martin
July 16, 2021, 09:55:50 AM
post Re: Skm flyback destroyer 🤗
[Transformer (Ferrite Core)]
Patrick
July 16, 2021, 09:54:50 AM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal