Author Topic: Recording a variac  (Read 526 times)

Offline klugesmith

  • High Voltage Engineer
  • ****
  • Posts: 378
  • Karma: +12/-0
    • View Profile
Recording a variac
« on: October 11, 2020, 06:18:10 PM »
Rikkitikkitavi might like this. 
A nice 1.4-kVA variac had a power cord so old, its rubber jacket was cracked and splitting along most of its length.  Was becoming scary to use.

It was time to replace the cord, which had 2 conductors and a polarized plug complementing the variac's output receptacle.
This variac is for the lab, not for a museum, so it received the cord from a dead MWO.  16 AWG with three conductors and a ring lug on the grounding conductor.  How to connect the ground?

Die-cast cover had a blind hole molded into one inside corner, as if for 3-wire corded model.
Not threaded, but matching the tap drill size for an 8-32 screw, like the long screws for cover attachment.
My only 8-32 tap has a long taper, so I needed to drill the hole a little deeper to finish the job.

[edit] The major diameter of 8-32 thread is 4.2 mm.  In my experience it's the "standard" thread for securing wires in household electrical devices in USA.   In the original Powerstat, all connections were soldered except for spade lugs under 8-32 screws at the internal variac terminal plate.
« Last Edit: October 11, 2020, 10:33:00 PM by klugesmith »

Offline johnf

  • High Voltage Technician
  • ***
  • Posts: 163
  • Karma: +5/-0
    • View Profile
Re: Recording a variac
« Reply #1 on: October 11, 2020, 08:44:54 PM »
I would have drilled a hole through the side offset from the cord grip to allow use of a nut and bolt and spring washer.
AS/NZS3100 states a minimum of a 4mm bolt that is solely used for earthing purposes

Offline rikkitikkitavi

  • High Voltage Experimenter
  • **
  • Posts: 89
  • Karma: +1/-0
    • View Profile
Re: Recording a variac
« Reply #2 on: October 11, 2020, 09:47:31 PM »
You sexy little thing :)
(the variac)

I presume you test GND from wall plug to the main body chassis, so that the screws holding the cover to the main body makes a good connection?
It looks like aluminium and hence some oxide might give a higher GND resistance. Anyhow nice work.

I have had a few Powerstats passing thru my hands, even all the way over to Sweden and feel their ruggedness and the impressive "Powerkote" and black goo on firmly anchoring the winding.

The old catalouge in a nice 60ies layout/type from Superior Electric.

I have modified one old variac in just the manner johnf describes, but it was a steel chassis, perhaps for magnetic shielding but I mostly use it with my insulating transformer OR a earth fault circuit breaker.  Anyhow  I cant choose not to because I had an electrican remake the entire fuseboard in my house just after moving in  and hence EFCB where mandatory but atleast I have split all 40some fuses on three groups so not everything goes black when I f-k up... and that I do sometimes.

A man can not have too many variacs

High Voltage Forum

Re: Recording a variac
« Reply #2 on: October 11, 2020, 09:47:31 PM »

 


* Recent Topics and Posts

post Re: Tesla Coil Show Controller Project
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Max
Today at 11:13:18 AM
post Re: repair of Panasonic microwave inverter
[Electronic Circuits]
Weston
Today at 10:08:34 AM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
Today at 03:20:42 AM
post Re: repair of Panasonic microwave inverter
[Electronic Circuits]
Twospoons
Today at 03:16:27 AM
post 3kW Cisco Server Supply teardown and help needed
[Electronic Circuits]
Da_Stier
July 23, 2021, 09:23:11 PM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
thedoc298
July 23, 2021, 08:05:58 PM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
futurist
July 23, 2021, 07:02:18 PM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
thedoc298
July 23, 2021, 05:33:57 PM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GKnapp
July 23, 2021, 04:51:37 PM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 23, 2021, 03:52:46 AM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
thedoc298
July 22, 2021, 10:59:32 PM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GKnapp
July 22, 2021, 08:50:34 PM
post Re: IGBT question
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
July 22, 2021, 08:47:23 PM
post Help needed - which IGBT module to buy
[Dual Resonant Solid State Tesla coils (DRSSTC)]
thedoc298
July 22, 2021, 07:01:24 PM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 22, 2021, 06:50:07 AM
post Re: Proper phase lead adjustment at the input
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 22, 2021, 06:39:37 AM
post Re: Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
alan sailer
July 21, 2021, 07:55:03 PM
post Horrible waveforms advice--just bad test setup?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
GKnapp
July 21, 2021, 06:34:13 PM
post Re: Global shutter synchronized to arcs?
[DSLR]
Uspring
July 21, 2021, 05:10:18 PM
post Re: Tesla Coil Show Controller Project
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
July 21, 2021, 12:42:29 PM
post Re: Proper phase lead adjustment at the input
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Chrisader
July 21, 2021, 08:15:00 AM
post Re: Proper phase lead adjustment at the input
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
July 21, 2021, 04:57:04 AM
post Re: Micro-power continuity checker.
[Electronic Circuits]
davekni
July 21, 2021, 03:50:33 AM
post Re: Skm flyback destroyer 🤗
[Transformer (Ferrite Core)]
oneKone
July 21, 2021, 01:50:19 AM
post Proper phase lead adjustment at the input
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Chrisader
July 20, 2021, 10:06:14 PM
post Re: Micro-power continuity checker.
[Electronic Circuits]
klugesmith
July 20, 2021, 06:24:29 PM
post Micro-power continuity checker.
[Electronic Circuits]
davekni
July 20, 2021, 05:37:36 AM
post Re: Help needed with SSTC. First TC build
[Solid State Tesla Coils (SSTC)]
davekni
July 20, 2021, 05:08:24 AM
post Re: Global shutter synchronized to arcs?
[DSLR]
davekni
July 20, 2021, 04:43:05 AM
post Re: Global shutter synchronized to arcs?
[DSLR]
TMaxElectronics
July 20, 2021, 12:09:36 AM
post Re: Help needed with SSTC. First TC build
[Solid State Tesla Coils (SSTC)]
AstRii
July 19, 2021, 11:13:13 PM
post Another question on CT Feedback
[Solid State Tesla Coils (SSTC)]
Maverikie
July 19, 2021, 08:56:04 PM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
newage
July 19, 2021, 07:09:56 PM
post Re: Global shutter synchronized to arcs?
[DSLR]
klugesmith
July 19, 2021, 06:49:08 PM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
klugesmith
July 19, 2021, 04:39:05 PM
post Global shutter synchronized to arcs?
[DSLR]
davekni
July 19, 2021, 06:32:35 AM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
MRMILSTAR
July 19, 2021, 05:22:51 AM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
newage
July 19, 2021, 04:24:38 AM
post Re: a typical sstc half bridge design, any considerations or tips?
[Solid State Tesla Coils (SSTC)]
eli
July 19, 2021, 12:35:18 AM
post Re: a typical sstc half bridge design, any considerations or tips?
[Solid State Tesla Coils (SSTC)]
Mads Barnkob
July 19, 2021, 12:15:43 AM
post a typical sstc half bridge design, any considerations or tips?
[Solid State Tesla Coils (SSTC)]
eli
July 18, 2021, 11:44:03 PM
post Re: HFSSTC design help and questions
[Solid State Tesla Coils (SSTC)]
eli
July 18, 2021, 09:33:40 PM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
johnf
July 18, 2021, 09:07:15 PM
post Re: Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
MRMILSTAR
July 18, 2021, 03:38:01 PM
post Best and stable version of video
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Transgarp
July 18, 2021, 03:33:31 PM
post Sync RSG motor problems - help and thoughts needed
[Spark Gap Tesla Coils (SGTC)]
newage
July 18, 2021, 01:30:46 PM
post Re: DRSSTC design advise / Primary peak current calculation
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Mads Barnkob
July 17, 2021, 10:05:39 AM
post Re: DRSSTC design advise / Primary peak current calculation
[Dual Resonant Solid State Tesla coils (DRSSTC)]
alan sailer
July 16, 2021, 11:01:43 PM
post Re: DRSSTC design advise / Primary peak current calculation
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Martin
July 16, 2021, 09:55:50 AM
post Re: Skm flyback destroyer 🤗
[Transformer (Ferrite Core)]
Patrick
July 16, 2021, 09:54:50 AM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal