Author Topic: How to design FPGA based on EDA technology?  (Read 426 times)

Offline Genterman

  • High Voltage Enthusiast
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
How to design FPGA based on EDA technology?
« on: December 01, 2020, 04:02:06 AM »
The traditional electronic system design method is compared with the modern electronic system design method, and the field programmable gate array (FPGA) circuit based on EDA technology is introduced. Programming application-specific integrated circuits (ASICs) have received more and more attention in digital system design and control circuits. So, how to design FPGA based on EDA technology?
« Last Edit: December 16, 2020, 07:47:28 AM by Genterman »

Offline johnf

  • High Voltage Technician
  • ***
  • Posts: 160
  • Karma: +5/-0
    • View Profile
Re: How to design FPGA based on EDA technology?
« Reply #1 on: December 01, 2020, 06:49:26 AM »
Genterman
Strange post but going on your title yes many EDA programs also have the ability to change the design into an FPGA to save vast numbers of logic chips and in some cases complete microprocessors as well. Some of the latest systems also include analog ie Psoc from Cypress but this is rare and these chips are somewhat fragile on the inputs to momentary abuse.
I still have to see proper low noise design  in these to compete with standard good design practice.

I saw attempts in the late 70s to make video digital CRT drives that also included the cathode drive with disastrous results a -90 volt pin not far from a digital input spelt disaster.

Offline petespaco

  • High Voltage Engineer
  • ****
  • Posts: 211
  • Karma: +11/-0
    • View Profile
    • French Creek Valley Activities
Re: How to design FPGA based on EDA technology?
« Reply #2 on: December 01, 2020, 06:30:33 PM »
Quote
I saw attempts in the late 70s to make video digital CRT drives that also included the cathode drive with disastrous results a -90 volt pin not far from a digital input spelt disaster.

About that time we started using one of the first 1600 bpi tape drives, from Ampex.   It had dozens of PC boards on a couple of backplanes.
They had +/- 12 volts and +/-30 volts running all over the place in addition to the the +5.    The backplane pins were tiny and real close together. To make it worse, the ground pins for each voltage were located between the plus and the minus.  So---- if your scope or meter probe slipped just the tiniest bit. you blew out dozens of pc boards.   Back then you didn't order new boards.  You just sat there replacing chips on double sided boards.

Pete Stanaitis
---------------

Offline Genterman

  • High Voltage Enthusiast
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: How to design FPGA based on EDA technology?
« Reply #3 on: December 02, 2020, 06:53:52 AM »
I am interested in FPGA design, but I am still a beginner. Thank you for sharing.

High Voltage Forum

Re: How to design FPGA based on EDA technology?
« Reply #3 on: December 02, 2020, 06:53:52 AM »

 


* Recent Topics and Posts

post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Rapy2
Today at 01:06:02 AM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
Today at 12:44:31 AM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Rapy2
Today at 12:41:33 AM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Rapy2
Today at 12:11:13 AM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
June 13, 2021, 11:52:11 PM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Rapy2
June 13, 2021, 11:38:44 PM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Rapy2
June 13, 2021, 10:26:51 PM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
June 13, 2021, 09:57:56 PM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Rapy2
June 13, 2021, 09:29:08 PM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
June 13, 2021, 08:53:25 PM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Rapy2
June 13, 2021, 07:22:05 PM
post Re: First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
June 13, 2021, 07:02:28 PM
post Re: HFSSTC with fixed crystal-controlled frequency
[Solid State Tesla Coils (SSTC)]
Steve Ward
June 13, 2021, 06:25:20 PM
post First middle sized DRSSTC - Phase lead tuning
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Rapy2
June 13, 2021, 02:48:59 PM
post OpenTheremin v3 loosing calibration after minutes
[Electronic Circuits]
gianpaolo
June 13, 2021, 12:00:09 PM
post Re: What is the guidence on SpaceX rockets based on ? PID's?
[General Chat]
Mads Barnkob
June 12, 2021, 07:28:03 PM
post Re: Rocket engine questions
[General Chat]
klugesmith
June 12, 2021, 07:23:12 PM
post Re: Rocket engine questions
[General Chat]
rikkitikkitavi
June 12, 2021, 12:24:06 PM
post Re: Nice PC Board Tesla
[Solid State Tesla Coils (SSTC)]
Da_Stier
June 12, 2021, 10:06:18 AM
post Re: Rocket engine questions
[General Chat]
plasma
June 12, 2021, 10:01:29 AM
post Re: Nice PC Board Tesla
[Solid State Tesla Coils (SSTC)]
Twospoons
June 12, 2021, 08:47:08 AM
post Re: What is the guidence on SpaceX rockets based on ? PID's?
[General Chat]
Patrick
June 12, 2021, 07:03:10 AM
post Re: Complications in the design of the first DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
PEDRO HENRIQUE
June 12, 2021, 06:42:56 AM
post Re: Nice PC Board Tesla
[Solid State Tesla Coils (SSTC)]
davekni
June 12, 2021, 04:20:53 AM
post Re: SKM100 Mini DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Willsmith001
June 11, 2021, 11:08:24 PM
post Re: How much propagation delay is too much propagation delay
[General Chat]
Willsmith001
June 11, 2021, 11:07:00 PM
post Re: Nice PC Board Tesla
[Solid State Tesla Coils (SSTC)]
Da_Stier
June 11, 2021, 12:33:55 PM
post Re: Nice PC Board Tesla
[Solid State Tesla Coils (SSTC)]
futurist
June 11, 2021, 12:03:24 PM
post Re: How much propagation delay is too much propagation delay
[General Chat]
davekni
June 11, 2021, 06:47:52 AM
post Re: How much propagation delay is too much propagation delay
[General Chat]
Power-Max
June 11, 2021, 06:32:02 AM
post Re: How much propagation delay is too much propagation delay
[General Chat]
davekni
June 11, 2021, 05:16:03 AM
post Re: SKM100 Mini DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
davekni
June 11, 2021, 04:53:50 AM
post Re: Why are SGT50T65FD1PN soo cheap on lcsc?
[General Chat]
Hydron
June 10, 2021, 11:51:17 PM
post Re: Rocket engine questions
[General Chat]
MRMILSTAR
June 10, 2021, 09:52:59 PM
post Re: Rocket engine questions
[General Chat]
Patrick
June 10, 2021, 09:16:25 PM
post Re: Why are SGT50T65FD1PN soo cheap on lcsc?
[General Chat]
Weston
June 10, 2021, 08:19:40 PM
post Fujifilm PMT module PMT12A, reverse engineering
[Detection, Counting and Measurements]
Mads Barnkob
June 10, 2021, 08:05:27 PM
post Nice PC Board Tesla
[Solid State Tesla Coils (SSTC)]
alan sailer
June 10, 2021, 07:46:12 PM
post Re: Is it possible to go fully CW with a DRSSRC?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Uspring
June 10, 2021, 06:31:40 PM
post Re: Why are SGT50T65FD1PN soo cheap on lcsc?
[General Chat]
rikkitikkitavi
June 10, 2021, 02:12:07 PM
post Re: Help for people buying the "12-48 Volt 1800/2500 Watt ZVS induction Heater"
[Electronic Circuits]
T3sl4co1l
June 10, 2021, 05:14:41 AM
post How much propagation delay is too much propagation delay
[General Chat]
Power-Max
June 10, 2021, 05:10:24 AM
post Re: Why are SGT50T65FD1PN soo cheap on lcsc?
[General Chat]
Power-Max
June 10, 2021, 04:50:34 AM
post Re: SKM100 Mini DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
alan sailer
June 10, 2021, 01:36:31 AM
post Re: Why are SGT50T65FD1PN soo cheap on lcsc?
[General Chat]
Steve Ward
June 09, 2021, 09:15:22 PM
post Re: Is it possible to go fully CW with a DRSSRC?
[Dual Resonant Solid State Tesla coils (DRSSTC)]
Power-Max
June 09, 2021, 08:02:15 PM
post Re: Complications in the design of the first DRSSTC
[Dual Resonant Solid State Tesla coils (DRSSTC)]
PEDRO HENRIQUE
June 09, 2021, 07:17:27 PM
post Re: Analog HFBR amplifier
[Electronic Circuits]
Max
June 09, 2021, 06:58:33 PM
post Aisler PCB Manufacturer
[Printed Circuit Board]
Max
June 09, 2021, 06:58:12 PM
post [WTS] (US) Large Ferrite U and E Cores, assorted types
[Sell / Buy / Trade]
Steve Ward
June 09, 2021, 05:44:06 PM

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 
SimplePortal 2.3.6 © 2008-2014, SimplePortal